Brand: GE

Type:DS200DCFBG1BLC

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Installing the MasterBus 300 Interface, CI855/TP853 The CI855 is powered from the processor unit via the CEX-Bus and requires therefore no additional external power source. The baseplate, TP853, provides two Ethernet ports for connection of redundant Ethernet network for MasterBus 300. Use the following procedure to install the CI855/TP853: 1. Mount the unit on the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65 and Installing the PM86x/TP830 Processor Unit in Single Configuration on page 78. 2. Connect the Ethernet twisted pair cable to the contact on the baseplate. 3. Connect the other end of the Ethernet cable to an Ethernet Switch. Ethernet twisted pair Connection The Ethernet twisted pair is connected via the 10BaseT RJ45 connector located on TP853. For a description of the connector, see Table 5 on page 84. If an interface to an AUI is required, a converter from 10BaseT to AUI is needed. The communication unit, CI855, can not provide power to the transceiver, therefore a separate power source must be used. Note that there is no unit redundancy for the CI855 unit.

The CI856 is powered from the processor unit via the CEX-Bus and requires therefore no additional external power source. Use the following procedure to install the CI856/TP856: 1. Mount the unit on the DIN-rail, see Mounting AC 800M Units onto DIN-Rail on page 65 and Installing the PM86x/TP830 Processor Unit in Single Configuration on page 78. 2. Connect the S100 I/O cable, TK575/TK580, to the contact on the baseplate. A bus extender, DSBC174/DSBC176/DSBC173A, must be used. S100 I/O Connection and Installation Connect the S100 I/O rack cable TK575/TK580 to the “I/O-labeled” 36-pin centerline miniature ribbon connector located on TP856. Installation of S100 I/O For installation of the S100 I/O-related components, see S100 I/O documentation. Note that there is no unit redundancy for the CI856 unit.