Brand:EMERSON

Type:1C31227G01

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Spare parts spare parts, the main DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Exchange of CPU in Redundant Configuration with BC810 If the BC810 is powered from an external power source, the entire CPU, with baseplate, can be replaced during operation. Follow the steps below to exchange a halted processor unit 1. Disconnect the Power Supply Socket from the processor unit. 2. Disconnect the RCU Link Cable and optical ModuleBus cable from the processor unit to be exchanged

Do not, under any circumstances, remove the RCU Link Cable from the primary CPU now running in a single state. Removing the cable might cause the CPU to stop.

3. Disconnect the Control Network cables. 4. Rotate the locking device to the SLIDE position (2) on the unit baseplate, see Figure 17 on page 69.5. Gently ease the unit/baseplate sideways in order to release the contacts of the unit. 6. Turn the locking device anti-clockwise to the OPEN position (1) and ease the unit baseplate outward and upward at the base. Lift the unit to remove it from the DIN-rail. 7. Mount the new unit (which already has the correct firmware installed). See Mounting AC 800M Units onto DIN-Rail on page 65. Fit the unit to BC810 CEX-Bus. 8. Reconnect the Power Supply Socket to the new processor unit. 9. Reconnect the optical ModuleBus and the RCU Link Cable. 10. Reconnect the Control Network cables. 11. Press the INIT push button on the replaced processor unit. 12. Observe the startup procedure and make sure that Dual mode is reached, that is, the Dual LED is lit on both processor units. The unit baseplates are easily disconnected from each other by gently prying them apart with a blade screwdriver (see Figure 23 on page 74). The F(ault) LED of the new processor unit is temporarily lit when the power supply is connected. This is not an indication of fault. Pressing the INIT button initiates the restart that is required to keep the new processor unit in redundant mode. During synchronization, the new processor unit inherits the IP address from the running processor unit