Brand:HIMA

Type:F7133

Origin: the United States

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

Spare parts spare parts, the main DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

The yellow DUAL LED is illuminated when the CI872 module is run in redundant configuration. The module that has the DUAL LED illuminated is the primary [active] module in a redundant configuration. Note: Even if the backup CI872 module runs with errors or fails in redundant configuration, the DUAL LED is still ON in primary CI872 module in redundant configuration.

Possible Cause 1: The CI872 module is in the process of upgrading the firmware (if the upgrade is in progress). Corrective Action 1: Wait for the firmware to be upgraded. Possible Cause 2: Fault in the CI872 module. Corrective Action 2: Hot remove and hot insert the CI872 module. Corrective Action 3: If the indication persists after performing the corrective actions 1 and 2, then replace the CI872 module. R(un) LED is ON The green R(un) LED indicates that CI872 is operational. Rx/Tx1, Rx/Tx2, and Rx/Tx3 LEDs are flashing There is one LED corresponding to each port on the CI872 module. When the LED corresponding to a port flashes, it indicates that communication is happening on that particular port. Rx/Tx1, Rx/Tx2, Rx/Tx3 LED is OFF Possible Cause 1: The fiber optic cable is not connected or it is not connected properly to the port. Corrective action 1: Do any of the following: • Check the corresponding optical cable connections, that is, the connections for reversed transmitter and receiver optical cables for that particular port, and the connections on the DOW MOD5 controller. • Check the Network Controller Board (NCB) on the MOD5 Controller connected to that particular port. Possible Cause 2: The configuration is not downloaded from the Hardware Tree (in the Control Builder) to the controller. Corrective Action 2: Ensure that the module is configured in the Hardware Tree for the correct position and the configuration is downloaded to controller.