MODEL

PS-05-15

OUTPUT

DC VOLTAGE

15V

RATED CURRENT

0.35A

CURRENT RANGE

0 ~ 0.35A

RATED POWER

5.25W

RIPPLE & NOISE (max.)   Note.2

120mVp-p

VOLTAGE TOLERANCE Note.3

±2.0%

LINE REGULATION    

±1.0%

LOAD REGULATION    

±1.0%

SETUP, RISE TIME

1000ms, 20ms

HOLD UP TIME (Typ.)

100ms at full load

INPUT

VOLTAGE RANGE

85 ~ 264VAC         120 ~ 370VDC

FREQUENCY RANGE

47 ~ 63Hz

EFFICIENCY (Typ.)

75%

AC CURRENT (Typ.)

0.15A/115VAC         0.07A/230VAC

INRUSH CURRENT (Typ.)

COLD START 30A/230VAC

LEAKAGE CURRENT

<0.5mA / 240VAC

PROTECTION

OVER LOAD

Above 105% rated output power

Protection type : Hiccup mode, recovers automatically after fault condition is removed

OVER VOLTAGE

17.2 ~ 20.2V

Protection type : Shut off o/p voltage, clamping by zener diode

OVER TEMPERATURE

Tj 140°C typically (U1) Detect on main control IC

Protection type : Hiccup mode, recovery automatically after fault condition is removed

ENVIRONMENT

WORKING TEMP.

-10~+60°C (Refer to output load derating curve)

WORKING HUMIDITY

20~90% RH non-condensing

STORAGE TEMP., HUMIDITY

-20~+85°C, 10~95%RH

TEMP. COEFFICIENT

±0.05%/°C(0~50°C)

VIBRATION

10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes

SAFETY&EMC

(Note 4)

SAFETY STANDARDS

EN60950-1 CB Approved by TUV

WITHSTAND VOLTAGE

I/P-O/P:3KVAC

ISOLATION RESISTANCE

I/P-O/P:100M Ohms/500VDC

EMI CONDUCTION & RADIATION

Compliance to EN55022 (CISPR22) Class B

HARMONIC CURRENT

Compliance to EN61000-3-2,-3

EMS IMMUNITY

Compliance to EN61000-4-2,3,4,5,6,8,11 Light industry level, criteria A

OTHERS

MTBF

1271.1Khrs min.    MIL-HDBK-217F (25°C)

DIMENSION

75*40*20mm (L*W*H)

PACKING

0.05Kg; 120pcs/6.25Kg/1CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance: includes set up tolerance, line regulation and load regulation.

4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.