MODEL

PM-15-24

OUTPUT

DC VOLTAGE

24V

RATED CURRENT

0.63A

CURRENT RANGE

0 ~ 0.63A

RATED POWER

15.12W

RIPPLE & NOISE (max.)   Note.2

240mVp-p

VOLTAGE TOLERANCE Note.3

±2.0%

LINE REGULATION    

±0.5%

LOAD REGULATION    

±0.5%

SETUP, RISE TIME

1000ms, 20ms/230VAC         1000ms, 20ms/115VAC at full load

HOLD UP TIME (Typ.)

100ms/230VAC         24ms/115VAC at full load

INPUT

VOLTAGE RANGE

85 ~ 264VAC         120 ~ 370VDC

FREQUENCY RANGE

47 ~ 440Hz

EFFICIENCY (Typ.)

81%

AC CURRENT (Typ.)

0.35A/115VAC         0.2A/230VAC

INRUSH CURRENT (Typ.)

COLD START 30A/115VAC         50A/230VAC

LEAKAGE CURRENT Note.5

Touch current <80uA/264VAC

PROTECTION

OVER LOAD

Above 105% rated output power

Protection type : Hiccup mode, recovers automatically after fault condition is removed

OVER VOLTAGE

27.6 ~ 32.4V

Protection type : Shut off o/p voltage, clamping by zener diode

ENVIRONMENT

WORKING TEMP.

-20~+70°C (Refer to derating curve)

WORKING HUMIDITY

20~90% RH non-condensing

STORAGE TEMP., HUMIDITY

-40~+85°C, 10~95%RH

TEMP. COEFFICIENT

±0.03%/°C(0~50°C)

VIBRATION

10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes

SAFETY&EMC

(Note 4)

SAFETY STANDARDS

ANSI/AAMI ES60601-1, TUV EN60601-1, IEC60601-1 approved

WITHSTAND VOLTAGE

I/P-O/P:4KVAC

ISOLATION RESISTANCE

I/P-O/P:100M Ohms / 500VDC / 25°C/ 70% RH

EMC EMISSION

Compliance to EN55011(CISPR11),EN55022 (CISPR22) Class B, EN61000-3-2,-3

EMC IMMUNITY

Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN60601-1-2, EN61204-3, medical level, criteria A

OTHERS

MTBF

499.7Khrs min.       MIL-HDBK-217F (25°C)

DIMENSION

75*53*22.7mm (L*W*H)

PACKING

0.14Kg; 120pcs/17.8Kg/0.97CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance: includes set up tolerance, line regulation and load regulation.

4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.

5. Touch current was measured from primary input to DC output.

6. Suitable for BF application with appropriate system consideration.