PRODUCT NUMBER

No. 1035

TYPE

A two-pack, water-based anti-corrosive based on epoxy resin with aluminum  Tripolyphosphate non-pollution pigment hardener.  

USES

Anti-corrosive paint for exposed steel of bridge, tank, ship and cabin etc. 

CHARACTERISTICS

1.  Low stench, fire-free because the water Thinner.

2.  Excellent coupling force and rust p properties and non-pollution.

3.  Low shrinks, high toughness and good adhesion.

4.  Excellent resistance to water and chemical solution.

FINISH

Flat

COLOR

White, Red, Green.

SPECIFIC GRAVITY

Above   1.2 kg/L (Mixture)

VISCOSITY (25 ℃)

80 ~ 100  KU (Mixture)

DRYING TIME(25℃)

Set-to-touch 0.5 hr

Dry Hard 4 hr

Fully Cured 7 days

OVERCOATING INTERVALS

10 hrs ~ 14 days

POT LIFE

4 hrs. (Mixture)(25℃)

MIXING RATIO

Base : Hardener = 92 : 8 (by wt.)

OPTIMUM FILM THICKNESS

Wet   100µ (4.0 mil)

Dry     50µ (2.0 mil)

THEORETICAL COVERAGE

9.1meter square/L 

34.4 meter square /Gal 

THINNER

Water  (0 ~ 5 %)

STORAGE SHELF LIFE

Minimum 2 years under normal storage conditions.

APPLICATION METHOD

AirlessSpray,Brush

VOLUME SOLIDS

Above 50%

NOTE

1.  Mix base and hardener according to ratio and stir thoroughly then keep  about 20 minutes before using.

2. Remove the moisture, grease, and dirt from painting surface.

3. It also can used inside the airtight but proper ventilation is good for All equipments must be cleaned by w immediately after use.

4. Since without the stable glue time, follow the pot life when applying.

5. Avoid applying paint in rainy or humidity above 85 % R.H.

6. When overcoating interval is exceed, surface must be roughened.