Cooling Tower Maintenance replacement fill PVC cooling tower fill packs
Negotiable
Min.Order:1
Hebei Lanyu Rubber & Plastic Products Co., Ltd.
PVC Corrugated Filling Sheet 750mm 950mm KK Type Cross-Flow Cooling Tower Fill
500mm*1000mm Industrial PVC Cooling Tower Packing Media S Wave Cooling Tower Filler Sheet
PVC PP Infill Sheet Roll Type Round Cooling Tower Filler Media
ML Cooling Tower PVC Fill Media Sheet Plastic MC75 MX75 Cooling Tower Fill Block
HoneyComb Fill Pack Waste Water Treatment Structured bio PVC filter block
305mm 610mm PVC honeycomb type corrugated PVC fills for cooling tower
Cooling tower fill is made of PVC or PP plain plate.
They are hot pressed in the certain mould, and then be produced according to different design and be used in different cooling towers, especially in the industrial cooling tower. As we all know, the main usage of the cooling tower fill is a media located in the bottom or middle of the industrial cooling tower.
Material | Sheet Spacing | Flute Angle | Media Pack Sizes: Depth(D), Width(W), Length(L) | Pitch | Sample | ||
PVC/PP | 0.75 in (19 mm) | 31° | Minimum | Maximum | Standard | ||
PVC/PP | D: 6 in (153 mm) W: 6 in (153 mm) L: 1 ft (305 mm) | D: 24 in (610 mm) W: 24 in (610 mm) L: 12 ft (3658 mm) | D: 12 in (305mm) or 24 in (610mm) W: 12 in (305mm) or 24 in (610 mm) L: 4 ft (1220 mm), 6 ft (1829 mm), 8 ft (2439 mm) or 10 ft (3048 mm) |
• Bevel Tips promotes drainage at fill pack interfaces. Note: Packs are always installed with Bevel Tips at bottom of pack.
• Patented "MA"(Mechanical Assembly) Technology for glue-free packs.
• Engineered microstructure for improved water distribution and thermal mixing
• High thermal performance
• Improved water distribution
• Proprietary edge trim that directs water to both sides of sheet
• Material meets Cooling Tower Institute (CTI) Standard 136
• Available in PVC