CSA463AE CSA464AE ABB module motherboard card controller (in stock)

CSA463AE CSA464AE ABB module motherboard card controller (in stock)

Our Email: 2235954483@qq.com

contact number:13313705507

contacts：HE

• Locate the pipeline coupling on the gas meter run, in close proximity to the

NGC. This allows the stainless steel sample line, from sample probe to

Chromatograph, to be as short as possible.

• The coupling should be mounted so the probe can be installed horizontally or

vertically on meter run pipe. This means the coupling should be mounted on

either the top or the side of the meter run pipe.

• Sample probe should not be mounted at the ends of headers, dead “T’s”, large

volume accumulators or other spots where gas is likely to be stagnant.

• Installation should allow the probe to penetrate the center 1/3 of the main gas

meter run. This allows sufficient heat transfer with the flowing gas sample.

Sample probe inlet should be high enough to avoid sampling of liquids at the

bottom of the pipe.

• The sample probe must be installed where probe has access to the fastest

flow of gas within the pipe.

• The sample probe should be mounted a minimum of five pipe diameters from

any device which could cause aerosols or significant pressure drops.