Brand: ABB

Type:PPC380AE01 HIEE300885R0001

Origin: the Swiss

Warranty: 365 days

Colour: new/used

Shipping method: Courier delivery

There are aluminum profiles for horizontal mounting. The aluminum profile gives an excellent grounding and rigid mounting of products concerned. The aluminum profile shall be fastened to the cabinet with at least 4 self-tapping screws.

The profile has grooves for screws that can be used for fastening the modules in an environment with high vibrations. Figure 16. Al-profile for DIN-rail support The AC 800M Controller and associated units must be unpowered and disconnected when being mounted onto a DIN-rail!

Mounting Procedure for PM8xx and CI8xx Units, Complete with Baseplates Before mounting any processor unit or communication interface onto the DIN-rail, read carefully the installation instructions provided with the equipment. Since the electronic unit and baseplate are supplied as a single unit, there is no requirement to separate them during the mounting procedure. Mounting the units onto the DIN-rail only requires a blade screwdriver that fits securely into the baseplate locking screw (1 mm slot). For further details on mounting procedure, see Figure 17 on page 69. Use the following procedure to mount the baseplates, complete with units: 1. Rotate the locking device to the OPEN position (1), hook the upper hook at the rear of the unit baseplate securely over the upper edge of the DIN-rail and gently snap the baseplate fully into the mounting position. 2. Rotate the locking device to the SLIDE position (2), slide the unit along the DIN-rail to the desired mounting position and using the connector plugs and sockets gently attach it to the adjacent unit baseplate. 3. When interconnection is complete, rotate the locking device clockwise to the LOCKED position (3). The baseplate is now fully locked into position and has a good ground connection to the DIN-rail. For further visual information on mounting AC 800M Controller units, see Figure 18 on page 69. This topic does not apply to PM891. See Mounting Procedure for PM891 Unit on page 70. It is not allowed to manipulate CEX bus baseplates in a powered and running system. Before changing or removing a baseplate, all CEX modules on that segment must be removed. To prevent damage to the pins, be sure the baseplate plugs and sockets are fully aligned as the units interconnect. Under no circumstances use excessive force! It is essential that the locking device be placed in the LOCKED position to avoid possible problems caused by vibration and/or intermittent grounding.