Delivery Time:5 working days after received your payment
Certification:CE

200bar 1/2 stainless steel air or water high pressure solenoid valve

1. Specification

1. For special very high pressure applications.

2. SUS316 material with good Acid and alkali resistant.

Model	HP250 HP350
Working Medium	Clean Air /Water
Working type	Direct action 2/2
Pattern	Normally close
Orifice	1mm
Insulation class	F class
Joint Pipe Bore	G1/8"-G1/2"
Pretection class	IP65
Working-pressure	0~25MPa 0~35MPa
Rated voltage	AC/DC24V-220V -10%~+10%
Power	AC22VA/DC14W
ure	45MPa
Material of Body	Stainless steel SUS316
Seal Material	PTFE

2.Dimensions

Maintenance instructions:
1. attention to check the use of components, in the transport process is damaged, and then install the use of.
2. When installing, please note that the gas flow direction and the takeover are correct.
3. when using, please strictly comply with the technical requirements, such as the operating voltage, operating frequency, working pressure, the use of temperature, the whole machine debugging, it is recommended to use a manual device debugging, and then through power debugging.
4. Please pay attention to dust, it is recommended to install the exhaust port or muffler muffler throttle.
5. When connecting pipe, pay attention to only release the strap around the joint may not exceed the end face of the tooth, and pay attention to the elimination of pipe fittings, metal particles inside the pipe, dust and oil, etc