VOK®-DF 037 silicone containing mineral oil emulsion defoamer

Free of VOC, used in waterborne latex paints, stucco and adhesives.

Product information

Chemical composition

Paraffin-based mineral oil and hydrophobic emulsion. Containing organic silicon.

Typical physicochemical data

The data given in this data page are only typical values, not technical indicators of the product.

Density (20 °C): 0.94 g/ml

Nonvolatile fraction (10 min., 150 °C): 53.5%

Water solvent:

Organic volatile matter content: <1500 ppm

Free of alkyl phenol ethyl oxide

Storage and transportation

Store and transport between 0 and 40 °C. Temperature sensitive emulsion. If the storage temperature is above or below the recommended range, it must be tested before use and, if necessary, re-emulsified at room temperature.

Application field

Coating industry

Product features and advantages

The defoaming agent can be used in a variety of latex paints and stucco, especially in the color volume concentration range of 50-85. The additive has good cost performance and contains organic silicon components which enhance the defoaming effect and are compatible with coatings.

Recommended use

This defoaming agent is especially recommended for use in latex paint/exterior paint and emulsion stucco. It can also be used in the production of emulsion adhesives.

Suggested usage

0.1-0.5 % additive amount (purchase form) based on the total formula. Up to 0.8 % under certain circumstances.

The above recommended dosage is for reference only, and the appropriate dosage needs to be determined through a series of tests.

Adding method and processing instruction

Under normal circumstances, 2/3 of the amount of the defoaming agent can be added to the abrasive and 1/3 of the amount can be added to the mixing or finished paint. In order to avoid defects, it must be added with sufficient shear force.

adhesive

Product features and advantages

The defoaming agent can be used for various emulsion adhesives. The additive has good cost performance and contains organic silicon components which enhance the defoaming effect and are compatible with coatings.

Recommended use

The defoaming agent is recommended for emulsion adhesives of polyacrylate and polyurethane. It is also effective for polyvinyl alcohol adhesives. It can also be used in the production of emulsion adhesives.

Suggested usage

0.1-0.5 % additive amount (purchase form) based on the total formula.

The above recommended dosage is for reference only, and the appropriate dosage needs to be determined through a series of tests.

Adding method and processing instruction

The defoaming agent should be added to the base material as early as possible. In order to avoid adverse effects, it must be added under sufficient shear force.