●Control axis: X-axis, Z-axis, Y-axis, c-axis (optional); 

●Interpolation method: x-axis and z-axis linear and circular interpolation 

●Position command range: ± 9999.999mm 

●Maximum speed: 30min 

●Maximum feed speed: linear 15m / min. 

●Feed per revolution: 0.01mm/r ~ 500mmr (1024p / or 1200p spindle encoder shall be installed)

●Acceleration and deceleration mode: linear rear acceleration and deceleration 

●Function of manual pulse generator: three gears of 0.001mm, 0.01mm and 0.1mm 

●Display type: 7-inch wide 16:9 LCD, 480 × 234tft color LCD 

●Real time clock display

●Machining track display

●There are 33 codes in total, including 3 single dependent cycle codes and 6 compound cycle codes.

●27 user macros

●Subroutine call, user macro program call

●Automatic chamfering

●Common thread (following spindle) flexible tapping

●Single head / multi head metric and inch straight thread, taper thread and end face thread, equal pitch thread and variable pitch thread

●The length, angle and speed characteristics of thread tailing can be set by program and parameters

●Thread pitch: 0.001mm-500mm (Metric)、0.06 teeth / inch - 25400 teeth / inch (British system)

● pitch error compensation: 360 compensation points for X, Z and Y axes respectively, and the compensation amount of each point is ± 0.007 × Compensation ratio

● tool compensation execution mode: moving tool coordinate offset (can be set through parameters)

● tool compensation: 64 groups of tool length compensation

● tip radius compensation

● reverse clearance compensation: (x, Z, Y axis) 0mm ~ 65.535mm

● adaptive tool rest: the maximum setting is 16 station electric tool rest, Liuxin tool rest (12 stations), dema tool rest (coding or counting)

● tool change mode: MD automatic absolute tool change or manual relative tool change, forward rotation tool selection and reverse locking

● tool setting mode: fixed-point tool setting, trial cutting tool setting and return to mechanical zero point tool setting

● tool position signal input mode: direct input

● spindle speed switching value control: S1, S2, S3, S4 four gear switching value control

● spindle speed analog voltage control: spindle speed 0V ~ 10V analog voltage control, four gear spindle automatic shift can be set

● spindle inching control

● spindle constant linear speed cutting function (under spindle analog control mode)

● manual / MDI / automatic control of spindle forward rotation, reverse rotation and stop

● coolant start and stop

● lubrication start stop

● MDI / automatic mode controls chuck clamping / loosening, and controls the advance and retreat of tailstock

● hydraulic chuck and tailstock

● I / O function diagnostic display

● 32 point input and 32 point output

● program capacity: 32MB, 500 programs

● format: relative absolute mixed programming

● subroutine: editable, supporting quadruple subroutine nesting

● front RS232 communication interface, which is standard configuration

● two way transmission of part program, parameter and other documents with PC to support system upgrading

● front USB interface makes it more convenient to transfer part programs, parameters and other files

● protective door

● tricolor lamp

● emergency stop

● hardware travel limit

● software travel check

● data backup and recovery

● switching power supply: GSK PB2 (supplied together, installed and connected)

● drive unit: DA98 series AC servo drive unit, GS2000 economical or Dy3 series, DF3 series stepping drive unit

● spindle drive unit: gs3000y-n economical type

● tool holder controller: GSK TB tool holder controller

●Horizontal、box 、 vertical