Outline

It is heterocyclic adhesive   which cures fast with UV light. it is temperature resistant and easy to   operate. No bubbles appear after curing thus making the surface smooth and   bright

Applications

It applies to the coating,   infiltrating and encapsulating of device surface, electronic components and   chips in electric engine, capacitor, thermocouples, transformers, rectifiers,   electronic modules LSI and other products to protect them against moisture,   chemicals, excessive heat, vibration, mechanical impact and thermal shocks.   It also applies to the bonding of metals, alloy, ceramics, glass and   transparent compound.

Features

It is transparent thick liquid.

It cures within 55 seconds to   5minutes when exposed to 1KW UV light with its wavelength from 360 to 400 nm.

It is resistant to shock,   ultraviolet light and extreme weather once it cures because it is durable and   with good ductility and low contraction coefficient.

Being heat-resistant, it adapts   to a wide range of temperature and bonds well under high temperature.

Being moderate in viscosity,   the surface appears smooth and bright after curing.

Apply the adhesive to the   surface of the substrates directly or fill it into the gap, then shine it   with UV light.

You.ll get long term durability   and resistance to moisture, chemicals, oils, and temperature extremes.

Non-toxic after it cures and it   is upto the RoHS standard.

Being stable, its storage time   is one year.

The main technical parameters are   as follows:

Heat resistance scope：- 70 °C—+ 350°C     weather resistant(non yellowing when   exposed to 300°C for 1hour, 250°C for 8 hours 200°C, 10000hours) , ;   tensile strength:48Mpa     compression strength: 223Mpa     bending strength:103.6Mpa    impact toughness: 15KJ/m*m       shear strength: 28.8 MPa （25℃） 15.4 MPa 200℃

volume resistance: 1.7×1015Ω.cm      sheet resistance   2.5×1015Ω

voltage withstand    28-35.5kV/mm     hardness  shore D 80

dielectric coefficient:4.1

Instruction

1. To get the best results, the   two surfaces being bonded should be free of oils, dirt, moisture and other   contaminants and should be slightly roughed or sanded to remove gloss.

2. Spray the adhesive on the   substrates, put them together and apply some strength on them, expose it to 1000W   UV light(360-400nm) and let it dry

Notes

1. Better to keep the working   place well ventilated.

2 .If it has contact with skin,   you should wash with soap.

3. It can be stored at   well-ventilated places with low temperature, and keep them away from fire.   Cover the lip after using it.