Product Details

430W 125mm diy cordless electric wood sanders wood sanders

Product Description

1. Speed selector

2. Adjustable handle

3. Adjustable handle locking knob

4. Hook and loop sanding pad

5. Motor cooling vents

6. Lock button

7. Power switch

8. Dust bag

9. Dust bag coupling sleeve

Product Specifications

Voltage	230 V AC, 50 Hz/ 120V AC,60Hz
Output power	430 W
Orbits/min.	6000-13000opm
Sanding pad diam.	125 mm
Sound Pressure (LpA)	81 dB(A) (K: 3 dB)
Sound Power (LwA)	92 dB(A) (K: 3 dB)
Vibration Value	10.8 m/s2 (K: 1.5 m/s2)

Features of electric wood sanders:

Dust box bag helps keep work area clean
Lock-on switch for continuous use with variable speed dial
8 hole hook and loop sanding base for through pad dust extraction
Front and rear soft grip

Operation of electric wood sanders:

Switching the sander on/off

The electric wood sanders is started and stopped by holding or releasing the power switch (7). To lock the power trigger (7) in the on position: Press the lock button (6) and trigger (7) simultaneously and then release the trigger (7) before the lock button (6). To disengage the trigger lock: Press only the power trigger (7) and then release it.

Attaching sandpaper

Make sure that the sandpaper is the right size (125 mm), has the correct hole pattern and is of the hook and loop (velcro) type. Line the holes in the sandpaper up with the holes on the sanding pad and press them firmly together.

Attaching the dust bag

The dust bag (8) pushes onto the sander’s coupling sleeve (9).

Setting the speed

The speed can be set from 6000 to 13000 orbits/minute. The speed can be adjusted using the speed selector (1), even during operation. Do not to exert too much pressure on the sander, especially at lower speeds when the motor is not cooled as much by the lower speed of the cooling fan.

Setting the angle of the handle

To adjust the handle (2), first loosen the locking knob (3), set the desired angle and then tighten the locking knob (3).

Care and Maintenance

Always keep the motor’s ventilation openings free of dust and debris.
Clean the machine as needed using a lightly moistened cloth and mild detergent if necessary. Avoid using abrasive cleaning agents and solvents.

Troubleshooting Guide

Problem	Possible Cause	Possible solution
The machine does not start.	No power.	Check that the wall socket works.
	Worn brushes.	Contact Customer Services if there is a motor or electrical fault.
	Short circuit.
	Faulty power switch.
The machine runs slowly.	Overloading.	Reduce downward pressure on sander.
	The motor is overheated.	Do not press down too hard.
	The sanding pad bearings are worn.	Contact our Customer Services.
Strange noise.	Mechanical fault.	Contact our Customer Services.
Strange noise.	Faulty windings.	Contact our Customer Services.
Heavy vibration.	Loose sanding pad.	Tighten the sanding pad and make sure it is attached correctly.
Sparks in the motor	Stuck carbon brushes.	Contact our Customer Services.
	Winding short circuited.
	Commutator short-circuited.

Packaging & Shipping

packed in color box or nylon bag