Product Specifications

Features of this electric sander tools:

1.Soft grip handle for comfortable extended use.

2.Flush sanding on 3sides.

Operating instruction

Intended use

This electric sander tools is Intended for dry sanding of wood, plastic, metal, filler, and painted surfaces

Replacing sand paper

1. Lift up the edge of the sand paper and pull it off from the sanding pad.

2. Clean the sanding pad.

3. Press the new sand paper firmly on the sanding pad. Align the holes in the sand paper with the holes in the sanding plate for best dust extraction.

Replacing the sanding pad

1.In order to replace the sanding pad, first remove the sand paper

2.Align the new sanding pad so that the drive engages in the recess in the sanding pad.

3.Immediately replace the sanding pad if it is damaged.

Starting/stopping

1.Start the tool by pressing the power switch.

2.Press in the lock button when the power switch is pressed for continuous operation.

3.Switch off the tool by pressing in and then releasing the power switch.

Sanding of sanded surfaces

1.Place the electric sander tools with the whole sand paper surface against the surface to be sanded.

2.Press evenly while working. Press harder will not speed up the work, hot will put more strain on the mouse sander and the sand paper.

3.Removal and the grinding pattern are primarily due to the sand paper's grit size, the speed of the sanding pad and how hard you press.

Coarse sanding

Use coarse sand paper. Press lightly for the best removal.

Fine sanding

1.Use fine sand paper.

2.Press moderately hard, and move the tool in circular movements or back and forth and up and down across the work piece.

3. Do not tilt the tool as this will leave marks in the sanded surface.

4. After finishing the work, switch off the tool and lift if from the work piece.

Pad brake

The pad brake lowers the speed when the mouse sander is unloaded, to reduce the risk of marks on work pieces when the tool is applied. If over time the no-load speed increases, the pad brake is worn out and must be replaced by a qualified service technician.