High sensitivity wall sensor

CE/ROHS

Welcome to use ES-P09A infrared motion sensor!

The product it has strong stability with multi-function, multi-mode for choosing. It is different with other items, it has PIR+MIC mode. It utilizes the infrared energy or sound from human, leading to the controlled-load is turned on in a short time. It could identify daylight and night by automatically. Easier installation, wider range for using.

SPECIFICATION:

MODEL	ES-P09A
DETECTION RANGE	9M
DETECTION ANGLE	160°
POWER SOURCE	110V-130V/AC 220-240V/AC
POWER FREQUENCY	50/60HZ
RATED LOAD	800W(110-130V/AC) 1200W(220-240V/AC)
TIME SETTING	10±3Sec~7±2Min.(adjustable)
WORKING HUMIDITY	<93%RH
WORK TEMPERATURE	-10°C~+40°C
INSTALLING HEIGHT	2m-4.5m
QUANTITY PER CARTON(PCS)	100

FUNCTION:

Ø LUX adjustment: The consumer can adjust work ambient light. It can work in the daytime and at night when it is adjusted on the “sun” position (max). It can work in the ambient light less than 3LUX when it is adjusted on the “moon” position (min). As for the adjustment pattern, please refer to the testing pattern.
Ø Time-delay is added continually: When it receives the second induction signals after the first induction, it will compute time once more on the rest of the first time-delay basic.(set time).
Ø Time-delay adjustment: It can be set according to the consumer’s desire. The minimum time is 10sec±3sec. The maximum is 8min±2min.
Ø Multi-working mode: You can select ON, OFF, PIR, PIR+MIC mode, if you select PIR+MIC mode, the lamp will be on automatically when you knock at the door or say “I am coming back” at night you come back home, it will make your home warmer and more romantic.
Ø The switch: “ON”,“OFF”,“PIR”,”PIR+MIC”.

INSTALLATION:

Ø Shut off the power.
Ø Loosen the connection column on the bottom of sensor, plug the wire into connection hole, tighten the screws; unload the surface of sensor, connect the sensor into connection box.
Ø If you want to install it in quadrate connection box, penetrate the setscrew into installation hole, block on radiator to aim at the installation hole on connection box, then tighten the screw; if you want to install it in circular one, you can use the same way as the quadrate, also adjust the sensor’s position, tighten the setscrew on surface, then the fixing arm will open automatically, fasten the connection box.
Ø Switch on the power then test it.

CONNECTION-WIRE DIAGRAM

(see the following figure)