Product Details

Product Description

Waterproof:IP20

Welcome to use ES-P21 infrared motion sensor!

The product adopts good sensitivity detector, integrated circuit. It gathers automatism, convenient safe, saving-energy and practical functions. It utilizes the infrared energy from human as control-signal source, it can start the load at once when one enters detection field. It can identify day and night automatically. It is easy to install and used widely.

SPECIFICATION:

MODEL	ES-P21
DETECTION RANGE	6M
DETECTION ANGLE	360°
POWER SOURCE	110V-130V/AC 220-240V/AC
POWER FREQUENCY	50/60HZ
RATED LOAD	800W(110-130V/AC) 1200W(220-240V/AC)
TIME SETTING	10±3Sec~10±3Min.(adjustable)
WORKING HUMIDITY	<93%RH
WORK TEMPERATURE	-10°C~+40°C
INSTALLING HEIGHT	1.5m-3.5m
QUANTITY PER CARTON(PCS)	50

FUNCTION :

Ø LUX adjustable: The consumer can adjust work ambient light. It can work in the daytime and at night when it is adjusted on the “sun” position (max). It can work in the ambient light less than 3LUX when it is adjusted on the “moon” position (min). As for the adjustment pattern, please refer to the testing pattern.
Ø Time-delay is added continually: When it receives the second induction signals after the first induction, it will compute time once more on the rest of the first time-delay basic (set time).
Ø Time-delay adjustment: It can be set according to the consumer’s desire. The minimum time is 10sec±3sec. The maximum is 10min±3min.

INSTALLATION:

Ø Shut off the power.
Ø Firstly, screw the middle part with the sensor part together, check the right figure, ( this part is screwed when leaving factory)
Ø Unscrew the beside of the middle part, and install the gimbals’ base in the ceiling or other place where you want to install, fasten the sensor part (first step in here) with the base, screw and fix the sensor part to base.
Ø Connect the power and load together according to the following figure.
Ø Switch on the power and test it.

CONNECTION-WIRE DIAGRAM:

(See right figure)