Product Details

Specifications

1.The machine injected
2.Best for the air filter
3.Two component adhesive
4.Attend the auto exhibition
5.Machine injection

double-component polyurethane adhesive

proportion ratio is 100:25

Two-component polyurethane adhesive for machine component proportion ratio is 100:25
	Material-A	Material-B
Physical nature	orange-red viscous liquid (color based on your request to configure)	brown-yellow liquid
viscosity	800-1000MPa.S(25°C)	25-50MPa.S(25°C)
density	1.02g/ml	1.02g/ml
package(as your request)	Plastic bucket or Tin bucket	Plastic bucket ,Tin bucket, Plastic pots
storage	1. Material-A and material-B can store up 3-6 months.
storage	2. To appropriate indoor storage above 15°C

Usage:

1.The material must be full rocked after each to the plastic injection machine plastic injection so that the A material mixing evenly.

1.Everytime the plastic injection machine plastic injection A material must be full before the shaking in order to the material until

2.AB material proportioning ratio of A:B=100:25 or 4:1.28°C,you can start operation

3.Material temperature controlled 24°C-28°C appropriate then you can start operation.

4. Must be clean before using the mould release agent (Note:

The new plastic mould can be wiped free)

5 .If A and B is not reaction please measuring A and B ratio.

6. A and B must be sealed to .To avoid the air and water vapor reaction, as a result affecting the effect of colloidal

Attention:

1. The products are generally stored in a dry room, and pay attention to water, moisture and sun. Must cover the plug and cover, to avoid absorbing rubber moisture in the air, affect the results

2. Mould must be painted in front of the mould release agent,to be poured glue dry before.

3. A.B glue in ordinary temperature of 25 °C properly used, if the temperature is too high or too low will affect the use effect. You must use artificial methods of cooling or heating.