Specifications

1.used for air filter
2.can be made end caps of filter
3.best for plate-type filter
4.have strong tensile and tear strength

Two component polyurethane adhesive for air filter, the component ratio is 100:25

Machine adhesive

Physical nature:

Color:  part-A: orange-red (color as your request)

       Part-B: brown-yellow

Physical form: viscous liquid (sticky liquid)

Viscosity: part-A: 800-1000MPa.s (25°C)

        Part-B: 25-50MPa.s (25°C)

Density: part-A 1.02g/ml

        Part-B 1.27g/ml

Instructions:

1. Material-A should be stirred or shaked well when you injected it into the machine.

2. Material-A and material-B are mixed at the mixture ratio 100:25

3. The material’s work temperature should be controlled 24°C-28°C then you can start operation

4. Brushing the mould with release agent before using the mould (notice: the new plastic mould can be wiped free)

5. If the response is inadequate, please measure the ratio

6. Material-A and material-B must be sealed to store. Or they can react with air or water, affect using effects.

Notes:

1.  Keep in airproof, cool and dry place. Inner plunger and outer cover should be tightly covered. Or glue stock will absorb water in air and affect using effects.

2. Material-A or material-B could be used normally in the temperature of 25°C, if the temperature is too high or too low will affect the results. Must use artificial means to cool down or heat up the temperature.

3. EXP: 6 months 

4. Brushing the mould with release agent before pouring the adhesive into the mould, after the release agent dry then pour the adhesive.

Features	Part-A	Part-B
Ingredients	Polyether polyols	MDI
Color	As your request	Brown-yellow
Viscosity (25°C)	800-1000MPa.s	25-50MPa.s
Density	1.02g/ml	1.27g/ml
Physical form	Viscous liquid (sticky liquid)
EXP	6 months
Application	Injection automobile air filter end cover
Package	Export standard seaworthy packing
Hardness	Shore A
notes	1.  Keep in airproof, cool and dry place. Inner plunger and outer cover should be tightly covered. Or glue stock will absorb water in air and affect using effects.
	2. Material-A or material-B could be used normally in the temperature of 25°C, if the temperature is too high or too low will affect the results. Must use artificial means to cool down or heat up the temperature.
	3. Brushing the mould with release agent before pouring the adhesive into the mould, after the release agent dry then pour the adhesive.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 If you have interest,do not hesitate ,hurry up!!!