TecMig Aluminum Alloy Mig Wires Tig Rods ER4043 AlSi5
USD $5 - $8 /Kilogram
Min.Order:1000 Kilograms
ER4043
AWS A5.10 ER4043
EN ISO 18273 S Al 4043 (AlSi5)
Description:
An Al-Si alloy welding wire can use where base metal require thermal treatment, mainly 6xxx series alloys. Higher silicon improve fluidity, make it become preferred choices of welders. This product is not sensitive to weld crack, it also can be used on weld forge and casting materials. Welding for 6xxx series alloys.
Welding Position:
Diameters:
0.8mm, 0.9mm, 1.0mm, 1.2mm, 1.6mm.
Typical Mechanical Properties:
Tensile strength(MPa): | 168 |
Yield strength(MPa): | 60 |
Elongation(%): | 19 |
Impact values(≥47J/+20℃): | -- |
Typical Chemical Compositon:
Si | Fe | Cu | Mn | Mg |
4.7-5.3 | 0.3 | 0.05 | 0.04 | 0.04 |
Cr | Zn | Be | Ti | Al |
0.05 | 0.05 | 0.0002 | 0.005 | Allowance |
Welding Current:(AC)
Dia:(mm) | 0.8 | 0.9 | 1.0 | 1.2 | 1.6 |
Current/A | 60-170 | 60-170 | 90-210 | 140-260 | 190-350 |
Voltage/V | 13-24 | 13-24 | 15-26 | 20-29 | 25-30 |
Note:
1.Rusty, oil stains, water and other impurity on the weld parts must be cleaned before welding.
2. Shield Gas:100%Ar or 75%Ar+25%He or 50%Ar+50%He
3. In order to get good welding bead, weld on thick plate should be preheat 100-200℃ before welding.
4. Tig rods ER4043 1.6mm, 2.0mm, 2.4mm, 3.2mm available