German technical background Volcker VOK ®- DF 011 Polymer defoamer without organic silicon for water-based systems (and radiation curing systems). It is especially recommended for two-component polyurethane system with good recoating performance.

Product Information

chemical composition

Polyolefin solution with hydrophobic particles

Typical Physicochemical Data

The data given in this data page are only typical values, not technical indicators of the product.

Density (20 ° C): 0.80 g/ml

Non volatile matter (10 minutes, 150 ° C): 29%

Solvent: hydrocarbon solvent/ethyl hexanol 21/1

Flash point: 72 ° C

Storage and transportation

The transportation and storage temperature must be between 0 ° C and 40 ° C. Stratification or turbidity may occur, mix thoroughly before use.

Application information

Coating industry

Features and Benefits

VOK ®- DF 011 is applicable to defoaming of water-based coatings (and radiation curing system), and the auxiliary agent does not contain organic silicon and mineral oil. Especially, it is recommended to be used in water-based two-component polyurethane system and prevent foam generated during the addition of curing agent. VOK ®- DF 011 is also suitable for varnish and ultrafiltration defoaming.

Recommended dosage

Waterborne two-component polyurethane system: 1-2.5%

Amount of additives (purchase form)

Based on the general recipe.

Other water-based systems: 0.1-1.5% dosage of additives (purchase form) is based on the total formula.

The above data are empirical dosage, and good dosage shall be determined through a series of tests.

Addition method and processing guidance

The defoamer can be easily added without grinding. Can be added to abrasives or paint mixes.