ARCHON W17vII Underwater Diving Video light Dive Video Torch LED Flashlight  1200 lumen Diving lamp

Archon W17V-II Diving Video Light

Model：W17V-II Diving Video Light

Bulb：CREE XM-L2 U2 LED[max1200lumens)

Color temperature：5000-5500K

Output levels：high>medium

Runtime：high 90min， medium 150min

Reflector：no hot spot design， no reflector

Lens：4mm toughened glass

Body material：durable aircraft-grade aluminum

Angle of Light beam：110°

Surface treatment：premium anodizing

Color：Black

Battery：18650 Li-ion battery with BMS*1

With battery over-discharging protection， and polarity reversing protection

Operation voltage：4.5V to 2.8V

Waterproof： 100 Meter

Dimensions：138mm[length]*36mm[dia. Of Light head]*24.3mm〔dia. of Light body)

Weight in air：approx.127g.[without battery) ； approx.176g.[with battery)

Weight in water：approx.92g.(with battery)

POWER INDICATOR：

Ring-shaped power indicator surrounding the switch Lights up in green， or yellow， or red

when the power capacity is above 70%， or reaches 70-30%or 30-10%.It flashes in red for

the power capacity between 10%and 5%， and switches off automatically when the power

capacity is below 5%.

LOW BATTERY WARNING：

The Light flashes 3 times when the power capacity reaches 10-5%； it repeats after 5

seconds， and then switches to lower brightness. The Light switches off automatically

when the power capacity is less than 5%.

BATTERY INSTALLATION：

1.Hold  the light with its head pointing upward， unscrew the light head

2.Remove the used battery from the battery compartment， if there is any； and put in the

fully charged battery per polarity signs.

3.Screw light head down. Do not over tighten to break the O-ring.

BATTERY CHARGING：

1.Plug the charger in the power socket， and the charger's indicator light is green in the

free-load status

2.Plug the battery in the slot of the charger. The charger's indicator light is redif the

charging is in process； and it turns green after the charging is completed.

3.After the battery is fully charged， unplug the charger， use or store the battery properly

MODES CHANGING：

1.Continuously quickly press the button switch to cycle through high， medium and off

2.The light can also be turned off at high brightness level by a user's long pressing the

button switch for three seconds

2.After each pressing， the switch will bounce back to its original position automatically

A CAUTION：

1.Please never attempt to repair or modify the light by yourself

2.Please check the light regularly for sharp edges， scratches or damages to the surface

Or O-ring， as this can cause the light to flood under pressure. PLEASE LUBRICATE THE

THREADS AND O-RING GROOVE， AND REPLACE THE O-RING TIMELY

3.Please rinse the light surface thoroughly after each use， and allow sufficient time for it

to dry both inside and outside before storage.

4.Please remove the battery for transport or storage. Do not lay the battery in a fire or

expose it to direct heat. Do not wet or hit the battery. Please charge the battery after

each use， or once every three months， to avoid over-discharging

5.Please never leave the light unattended when it is on

6.Please keep the device out of the reach of children or pets

7.Please never shine the light to human or pet's eyes.

8.Please use the battery with re/discharge protection circuit board or BMS[Battery

Management System) for this Light.