ARCHON D15VP Two-in-One Diving Video &Spot Light Dive Video Torch LED Flashlight  1300 lumen Diving Spot Torch

Model：D15VP Two-in-One Diving Video & Spot Light

Bulb：White[video light]CREEXM-L2U2LED*2(max 1300 lumens)， White[spot Light)

CREE XM-L2U 2(max 860 lumens) ， Red CRE EXP-EN3LED*2(620nm， max 200 lumens)

Color temperature：5000-5500KWhite(video Light)， 6500K White(spot Light)

Out put levels：White[video light) >White(spot Light] >Red

Runtime：White[video Light) 90min， White(spot Light] 120min， Red180min

Reflector：glossy aluminum reflector[spot Light only]

Lens：4mm toughened glass

Body material：durable aircraft-grade aluminum

Angle of light beam：110°(White video Light] &30°(White spot Light]

Surface treatment：premium anodizing

Color：Black

Battery：18650 Li-ion battery with BMS*1

With battery over-discharging protection，and polarity reversing protection

Operation voltage：4.5V to 2.8V

Waterproof： 100 Meters

Dimensions：134mm(length] *36mm[dia. of light head] *24.3mm(dia. of Light body)

Weight in air：approx.127g.(without battery) ； approx.176g.(with battery)

Weight in water：approx.92g.(with battery)

POWER INDICATOR：

Ring-shaped power indicator surrounding the switch lights up in green， or yellow， or red

when the power capacity is above 70%， or reaches 70-30%or 30-10%.It flashes in red for

the power capacity between 10%and 5%， and switches off automatically when power

capacity is below 5%.

LOW BATTERY WARNING：

The Light flashes 3 times when the power capacity reaches 10-5%； it repeats after 5

seconds， and then switches to lower brightness. The Light switches off automatically

when the power capacity is less than 5%.

BATTERY INSTALLATION：

1.Hold the Light with its head pointing upward， unscrew the light head

2.Remove the used battery from the battery compartment， if there is any； and put in the

fully charged battery per polarity signs

3.Screw light tail down. Do not over tighten to break the O-ring.

BATTERY CHARGING：

1.Plug the charger in the power socket， and the charger's indicator light is green in the

free-load status.

2.Plug the battery in the slot of the charger. The charger's indicator Light is red if the

charging is in process； and it turns green after the charging is completed.

3.After the battery is fully charged， unplug the charger， use or store the battery properly

MODES CHANGING：

1.Continuously quickly press the button switch to cycle through White video Light， White

spotlight， Red and off

2.The light can also be turned off at White video light or Red light level by a user's long

pressing the button switch for three seconds