Name: Bacterial cell tissue culture in co2 incubator of Kenton instrument
Brand: Kenton
Availability: InStock

Product Details

co2 incubator method of use

1. Install the carbon dioxide special pressure reducing valve on the carbon dioxide cylinder, the joint shall not have leakage phenomenon. Cover the pressure relief valve output connector with pressure rubber hose and connect it with the carbon dioxide inlet connector behind the incubator. Then use the compression ring to tighten it. There must be air leakage at the compression joint. Carbon dioxide cylinder gas main valve does not open.

2. Before switching on the power, clean the room with alcohol, and then use ozone sterilizer to sterilize for one hour.

3. Connect the water pipe to the lower left side of the tank to add and drain water (provided by the user of the tank), open the outer door of the tank and visually observe the water level at the bottom of the studio to about 10 ~ 15mm.

4. boot

Power on, the main power switch is set to "1", and the power indicator is on.

1) box temperature and parameter setting

It says "888..." After 3 seconds, enter a state of normal operation, press the main heating temperature setting button "Tset" box set temperature controller into the state, the controller temperature window bottom set prompt "SP" display box, display boxes on the temperature set point, the user can according to need to modify the parameters, click the button again, exit temperature box set status, the value is automatically saved. Long press "Tset" for 3 seconds to enter the setting state of internal parameters of the box temperature, and then long press this key for 3 seconds to exit the state.

co2 incubator main technical indicators

Chamber size: 500×400×400 (80L); 650×550×500 (160L);

2. Temperature setting range: ±5.0 ~ 50.0℃;

3. Temperature fluctuation: ±0.5℃;

4. Temperature distribution uniformity: ±0.5℃ (±1℃);

5. Set value: +1℃ tracking alarm, and cut off the heating power;

6. Temperature recovery time: ≤15 minutes (37℃);

7. Carbon dioxide control range: 0 ~ 20%v/v;

8. Flow meter: air 100-1000ml /min; Carbon dioxide 10---100ml/min;

9. Recovery time of carbon dioxide concentration: concentration value ×1.2 minutes;

10. Power supply: 220VAC, 50Hz;

11. Power: ≤350W (80L), ≤550W (160L); 12. Dimensions: 835×550×550 (80 liters); 985×700×650 (160 liters);