co2 laser power supply, buy PS-N100 100W EFR CO2 laser power supply for EFR CO2 laser tube F4 and ZN-1450 on China Suppliers Mobile

Product Details

PS-N100 100W EFR CO2 laser power supply for EFR CO2 laser tube F4 and ZN-1450

OVERVIEW

EFR power supplies for EFR CO2 laser tubes adopt zero-current half-bridge soft-switch circuit to ensure the equipment has advantages of high efficiency, rapid response speed and simple port control, and applicable to two signals – high and low level. TTL level is to control the laser on/off, in the meantime, the power supply has an anomalistical protective switch to check whether the outer water and air, etc. are free or not.

Adjust the laser power: Input imitative signal, from 0 to 5V, or input PWM signal to control the output laser power.

PICTURES

PS-N100 100W EFR CO2 laser power supply for EFR CO2 laser tube F4 and ZN-1450

PARAMETERS

Model	PS-N60/80	PS-N100	PS-N130/150
Input Voltage	AC220V or AC110V(please specify the voltage when placing an order)
AC Frequency	47-440Hz
Cold Surge Current	≤60A (input AC220V)/≤30A(input AC110V)
Leakage Current	≤0.7mA(input AC220V)/≤0.4mA(input AC110V)
Max Output Voltage	DC 35KV	DC 50KV	DC 50KV
Max Output Current	DC 35mA	DC 35mA	DC 38mA
Efficiency	≥90% (full-load)
MTBF(Mean time between failures)	≥10000 hours
Response Speed	≤1ma(from switching signal to the output current achieve to 90% of Pre-set current)
Control Port	TTL Level switch control, valid level has high/low choise
Voltage-resisting	Input-output, input-machine shell; AC1500V 10mA 60s output cathode is connected with the machine shell
Protection	Used in open-circuit state within a short time (request that the outer shell be well connected with the ground, in the meantime, avoiding arcing between anode and machine shell.)
Working Environment	Work temperature: (-10-40)℃ Relative humidity: ≤90%
Cooling Type	Forced air cooling
Size LWH(mm)	250139107	285139107	352139107

ADVANTAGES

1. Excellent compatibility;

2. To lengthened the serice life of the tube;

3. The feedback port in the power will be used for closed-loop control and operating current checking;

4. Open power protection in the power has these function: the power can work for a short time in the state of open circuited while the case touch the ground well-- avoid damage to the machine, finally, lengthened the service life of the power.

AGING CHECK BEFORE LEAVING FACTORY

Each power supply before sold will go throuth the ageing tests, which is made at tempareture 65ºC with full-load condition and sustains 10 hours, is turned on/off 300 times within 7 seconds.

COMPANY INFORMATION

Shenzhen Reliable Electromechanical Technology Company is a professional supplier for high quality laser engraving&cutting machine and parts, located in Shenzhen City, Guangdong Province.