HY-E80 high quality 80W CO2 laser tube power supply for long life EFR CO2 laser tube

HY-E80 power supply for CO2 laser tube adopts zero-current half-bridge soft-switch circuit to ensure the equipment has the following advantages of high efficiency, rapid response speed and simple control port, and, applicable to high/low level signal. TTL level is to control the on/off of the laser with an anomalistic protective switch to check water-flow, ventilation, etc.

Adjust the power: Input analog signal(0~5V) or PWM to control the output power.

Aging check before consignment

Each power supply before selling will go through the aging check:

(1) sustain 10 hours at temperature 65 ℃ under full-load condition;

(2) 300 times on/off check for 7 seconds.

Characteristic of HY-E80 power supply:

(1) Excellent compatibility;

(2) To lengthen the service life of the tube;

(3) The feedback port in the power supply will be used for closed-loop control and operating current checking;

(4) Open power protection in the power supply has these functions: the power supply can work for a short time in the state of open circuit while the case touches the ground well so as to avoid damage to the machine, and finally to lengthen the service life of the power supply.