Specifications:   

Steel structural floor panel is the type of steel construction material with character of low light, hard, easy to install, which extensively apply in constructing skyscraper, residential building and bridge. HBYX series steel structural floor panel with the feature of reliable, convenient operation, automatic can be used in various steel structural floor panels forming.
     This machine is composed of uncoiler, feed leading table, main forming machine, punching system, cutting device, hydraulic station and computer control system.

Main Technical Specifications of Floor Deck Roll Forming Machine:

Floor Deck Roll Forming Machine chart 
Auto-de-coiler------roll guider------leveler and feeding------continuous hole punching-------forming------positioning and cutting-------collection

Floor Deck forming machine Performance 
Range of raw material 
Material: Galvanized zinc plate, low carbon steel plate, such as Q235 
Thickness of raw material: 1.0≤-≤2.0mm 
250≤-≤400mm 
Width of raw material: 250≤-≤400mm 
Production area: 30m X 3m 
Total power: 42KW 
Air supply: 0.9m3/min, pressure is: 0.6-0.7MPa 
Main parts parameters: 
Auto-de-coiler 
Inner expansion type with max. 3tons 
Drive: 2kw frequency change motor 
Inner diameter of coil 500~520mm, out diameter: ≤1200 
Speed control by auto induction device. 
One pair of horizontal roll and two pair of vertical rolls. 
With function of homonymous and guide movement.

Floor Deck forming machine Level machine 
Correction roller: Up 4/ down 4 with one pair of feeding roller front and back each. 
Lever range: Max. Length450mm, max. Thickness 1-2mm 
Drive: 4kw frequency change motor 
Drive: 1kw electrical control servo-feeding. 
Feeding distance: Can be set up as request 
Continuous hole punching part 
Punching machine: JE21-80 (80 tons)

Floor Deck Roll Forming Punching mould 
Material of punching moulds: Cr12 quenching treatment, hardness58-62.

Main Floor Deck Roll Forming machine 
Frame: Dragon type frame, side roller change system. 
Forming frame: 18 stations 
Max. Feeding width≤400mm, max. Thickness: 1.0≤ -≤2.0mm 
Diameter of roller shaft: 70mm, 
Material of roller shaft: 40Cr, heat treatment. 
Material of roller: GCr15, quenching treatment, hardnessHRC56-62 
Motor power: 22kw frequency change motor, ZQ400 reducer. 
Drive type: Gear drive type for each frame (excepting main drive)

Flat Sheet Slitting and Cutting Machine
Cutting section 
Hydraulic cutting 
Hydraulic station: 5.5kw 
Material of blade: Cr12, quenching treatment. 
Electric control 
PLC control system, LCD operation with encoder for length controlling.