High quality magnetic wireless vehicle detection sensor for parking lot management system

Rosim smart parking guidance sensor system include  two WVD-130 and one WAP-348.

The wireless vehicle detector can be installed in entrance and exit for detecting vehicle ,once a car drive off it ,it would be send a real time information to wireles access point which will collect this information and transmit to user 's serve  so the  user can  know how many available lot in the parking lot by caculated .A simple parking guidance system was built fastly.

ROSIM's wireless vehicle detector completely replace traditional inductive loop detector 

How does it work?

By capture the tiny change of magnetism caused by the passing vehicle, WVDs (Wireless Vehicle Detector)  calculate the vehicle velocity, length, type and occupy rate rapidly, and then send these information to the WAPs (Wireless Access Points), which will receive all the on line WVDs’ information and transmit these data to the user systems through RS-232/485, Internet, GPRS, etc..

 Cetifications

Major Advantages

a)  Install fast. It is only almost 6 minutes that is needed to install one wireless vehicle detector in the road, after installation, the traffic control could be released immediately;

b)  Work all-weather. Bad weather for example heavy fog, snow and rain makes no difference;

c)   No damage to the road. There’s no need to cut slots on the road surface and place cables or wires as the installation of loops, but only a tiny hole with the size Φ 120/H 100 mm, which makes WVDs become the most suitable vehicle detecting solution on the city high-way and bridges;

d)   About 10 years long life span. With high standard water proof and anti-press characteristics,  WVD wireless vehicle detector can even be used in the damaged or distorted roads where loops cannot be installed.

e)  Cost saving. You just can use the cement which is about $2 for 3-4 sensors.

f)   Easy to maintain. Unlike the loops that are easily to be damaged but difficultly to be repaired, WVD wireless vehicle detector supports firmware updating over the air. No need to re-cut the slots, no more materials needed, and all of what you need is to take almost 10 minutes for the devices wireless updating;

g)  Low operation consuming. Due to the ultra-low power design and battery supply solution, WVD wireless vehicle detector’s consumed power is very lower than any other detectors like loops, video, micro-wave etc. in the market. This appears more and more significantly to our environments;

h)  Replace loops seamlessly. The same installation position and compatible output signals makes it easily and simply to replace loops in your system directly.

Application

Installation

 In the application of traffic signal controlling, traffic flow monitoring, traffic guiding, speed enforcement and red light enforcement, the installing place of the wireless vehicle detector (WVD) is the same as loops. The installation and signal connection of wireless access point (WAP) is compatible to loop controller, see following figure of wireless vehicle detection system.

Our Service

Rosim ITS provides our customers high quality wireless loop vehicle detector for vehicle detection traffic signal control system solutions, all the products support wireless updating, which makes it easily to maintain. Also, Rosim ITS provides 24 hours on-line supports.

Competitive Wireless traffic magnetic vehicle detector sensor for management system detection

More products:
http://www.china.cn/product-detail/2014-new-generation-of-wireless-vehicle_1710694420.html

Thank you for your attention, for more information, pls feel free to contact Kate!