Specifications

ptfe joint sealant
1.one part,high strength,red paste
2.a soft purple layer after cured
3.fill 0.20mm gap
4.50ml/soft tube

   

                    Kafuter K-0510 Flange ptfe Joint Sealant                                         

Application

 

 (1) Fill the gap of 0.2mm, it seals colse fitting joints between rigid metal surfaces and flanges and will flex with minor flange movements.

 

(2) used as a form-in-place gasket for pumps, thermostats, compressors, transmission housings and axle covers. especially sealing of the rigid-structured flange in gear boxes, engine crankcases, and flange plates, etc.

 

Characteristics

One-part, general purpose, high intensity anaerobic flange sealant, can replace any gasket instantly, good medium resistance, can form a soft layer after cured.

 It cured when confined in the absence of air between close fitting metal surfaces.

 

Typical properties

 

Appearance	red paste
Viscosity(cps/25°c)	≥220000
Specific Gravity	1.05~1.15
Flash Point(°c)	>108
Initial Cure Time(min)	≤60
Full Cure Time(25°c)	24h
Max Seal Pressure	≥36
Work Temperature(°C)	-54~150
Storage Life(25°c)	12 months at 15°c~28°c

 

 Packing Specifications

 

50ml/soft tube	10tube/box	100tube/carton
300ml/plastics tube	30tube/box

 

User's Guide

 

1. For best performance bond surfaces should be clean and free from grease.

2. The product is designed for close fitting flanged parts with gaps up to 0.25mm.

3. Apply manually as a continuous bead or by screen printing to one surface of the flanges.

4. Low pressures (<0.2mm) may be used when testing to confirm a complete seal immediately after assembly and before curing.

5. Flanges should be tightened as soon as possible after assembly to avoid shimming.