OFPM-2000A four square fiber optic polishing machine 

1. Designed for fiber optic connector polishing, 220V AC 50/60Hz input voltage.

2. It is widely used for polishing UPC and Angled connector of SC / FC / E2000 / ST / MU and LC.

3. Different connectors request different type polishing jigs, low cost for polishing jigs.

4. Speed adjustable and applicable to manufacture connector with high quality requirements.

5. Polishing high efficiently, jigs could polish 18 or 40 connectors per cycle.

6. Use with Neoholder® SC-48-F25, and polish 48 ferrules per cycle.

7. Easy to handle and compact size.

Input Power: 220VAC 50/60Hz

Fuse Type: 220VAC 1000mA

Standard configuration:

Optional Fixture/Jig List:

Rubber Pad and Polishing Film:

Orders would be shipped within 3 working days upon receiving cleard payments when stock lasts. Delievery time depends on the shipping method, the following is the typical time:

Faster courier(Such as EMS, DHL, UPS...) would take 3-7 days;

Air mail(Hong Kong air mail, Singapore air mail) would take 10-20 days.

Package might be delayed occasionally by the Customs or the carrier, we sincerely hope each customer could give a few more days when this happens Beijing W&F technology Co.,LTD is founded in 2006. It is a hi-tech company specialized in manufacturing and trading fiber splicing machine and testing equipments . Our company is one of the biggest communication test instrument suppliers which is located in Beijing - the capital of China.

1.What’s the lead time for all the goods that I required?
    W&F :About the 3-4 working days after getting payment.
2.What’s the warranty for your products?
   W&F: Normally it is 2 years.
3.What’s the MOQ for your products?

    W&F: 1PC is ok ? 

4. How will you ship to us ? 

    W&F: Normally it will takes 3-5 days by DHL or FedEx  

5.My fusion splicer machine always has a larger splice loss,what reasons caused it? How solve?
W&F: 1).the electrodes are aging,you need to change new ones
          2).the electrodes are not installed very well,you need to re-install and fix the electrodes well.
          3).discharging current is not good,you need to do discharging experiment to make the current get the right point
6.splicing machine shows loss is not large,but it's larger when testing use a OTDR,what causes?how solve? 

W & F :1).the electrodes are aging,you need to change new ones 
            2).discharging current is not good,you need to do discharging experiment to make the current get the right point 
            3).Optical fiber end face is bad,there is something wrong with the cutting blades.You need to adjust the fiber cleaver & cutting blades to make sure end face is better
            4).There has dust in V groove,you need to clean V groove, microscope, electodes etc  

You are always welcome to contact us!  

Ms. Betty Cao    

Skype :bjwftd2