Tile Ball Mill
Negotiable /Piece
Min.Order:1 Piece
Zhengzhou Prominent Technology Co., Ltd.
When selecting jaw crusher liner, the user typically must consider three factors: production, consumption, liner wear. According to the following general principles: maximum feed size, change size, and feed particle size distribution, material hardness, wear resistance materials. Jaw crusher liner longer the power is higher, hard materials to choose a short liner, soft material selected long liner, in the distribution of materials, fine material to choose a short liner, coarse material selected long liner. of Tile Ball Mill
Rotating System: the movable jaw, eccentric shaft, consisting of bearings, pulleys and other parts, is the main part of the jaw crusher drive and endurance.
Features
Tile Ball Mill Long Service Life, Large Feeding Size, Stable Reasonable Design, Installation Guide,
Tile Ball Mill Operation Notes:
When crushed as a result of the crushing cavity material obstruction caused by parking, you should immediately turn off the power to stop running, will clean up after the crushing cavity material before re-starting.
Maintenance & Attention
Monitoring systems can impact crusher crusher for health monitoring at any time, you can monitor the signal with the main control system interlock to ensure safe and reliable operation of the machine. Impact crusher drive system uses a mechanical coupling of the motor + + + V-belt crusher way, can effectively improve the performance of the motor starts, the motor can be up and running smoothly. Belt drive mode can serve a dual function of overload, the motor drive system requires low power, significantly reduce operating costs. This driver program is economical and practical, high-performance, secure and reliable drive solutions.
To Choose a Right Tile Ball Mill
Select comprehensive proposal cone crusher: 1, material handling hardness, hard broken, should choose multi-cylinder hydraulic cone crusher; 2, handle high abrasive, large water content material, should choose the speed cone crusher; 3, the processing of final products, especially thin material, should choose high-speed cone crusher; 4, treatment of soft material, should choose the bottom of single-cylinder hydraulic cone crusher, etc.