Specifications

Track Jaw Breaker Long Service Life, Large Feeding Size, Reliable Motor, Low Cost Spare Parts,

Jaw crusher pre-start checks whether the ore crushing cavity or other debris should be removed immediately. Jaw crusher before starting guards should carefully check is good, found to be unsafe, should immediately eliminate it.After Track Jaw Breaker start, if found to have unusual circumstances, should be immediately stopped, the reason to exclude risks to be identified before they start again. After XINGHAO Track Jaw Breaker normal operation before feeding. Be crushed material should be uniform to join the crushing cavity, and should avoid feeding side, to prevent the sudden increase in load mutation or unilateral. After XINGHAO Track Jaw Breaker normal operation before feeding. Be crushed material should be uniform to join the crushing cavity, and should avoid feeding side, to prevent the sudden increase in load mutation or unilateral of Track Jaw Breaker

After PE 700* 100 M 1 Track Jaw Breaker normal operation before feeding. Be crushed material should be uniform to join the crushing cavity, and should avoid feeding side, to prevent the sudden increase in load mutation or unilateral Lubrication jaw crusher can often work and timely attention to ensure the normal operation of the friction surface and extend the life of the equipment. Add as 50-70%, the carrying capacity of oil must be replaced every three months, oil change, application of clean gasoline or kerosene carefully cleaned roller bearings. Bracket and bracket pad contact, before oil began to enter the crusher. Steel jaw crusher requires large furnaces for melting the steel mold casting. Now basically used electric furnace, the higher the production process. General by a professional casting plant jaw crusher housing body processing.

 

Features

Track Jaw Breaker Long Service Life, Large Feeding Size, Reliable Motor, Installation Guide,

Track Jaw Breaker Operation Notes:

Cut off operations and emergency stop processing 1, ore crusher All cut off must be ruled out before stopping. 2, cut off should be the first stop to the mining system (ie trough feeder). 3, vacuum cleaners and water system before stopping after 5 minutes. 4, the following conditions should an emergency stop: (1) The main shaft bearings or moving the jaw abrupt temperature exceed 80 ℃, the surface phenomenon is touching the back of the bearing can not be sustained for a second time. (2) before or after the thrust plate fracture. (3) belt loose bolts or other transmission parts likely to break when flying wounding. (4) Motor smoke "sweep bore."

 

Maintenance & Attention

Crusher during normal operation of the spring is not moving, only the iron in the crushing chamber falls crusher overload occurs when the lift spring support sleeve is compressed phenomenon. Upper crusher beat occurs during normal operation, this is not a normal phenomenon must carefully analyze the causes and take measures to remove.If the error will not be able to compress the springs work properly, but the damage to the parts may occur because the crushing force of the compression spring will cause an increase in

 

To Choose a Right Track Jaw Breaker

Composite hammer, while having a higher life, but its casting and heat treatment process is complex. For this reason, in recent years developed a variety of low-alloy steel hammer, there 40CrMnSiMoRe been promoting low-alloy steel hammer. 40CrMnSiMoRe steel alloying elements, low production cost, simple process, you can get the required mechanical strength through the appropriate heat treatment. After analysis of the health of the hammer and experiments on the crusher, confirming the performance indicators in line with the kind of material hammer, hammer can be used as a good material. On the plant hammer crusher, 40CrMnSiMoRe high manganese steel hammer and hammer were worn compared. Test Method is mounted on the two rows of hammer crusher, each mounted in a row, with the machine running, test results: 40CrMn-SiMoRe hammerhead run 21d, the high manganese steel hammer run 14d, due to the two hammerhead wear different lengths, so use to measure the actual length of the wear life of more practical.