Specifications

Tin Crusher For Sale Long Service Life, Large Feeding Size, Stable Reasonable Design, Mutiple Size,

Jaw crusher at work, feeding should be uniform, there can skew phenomenon. If the feed production capacity will be reduced inequality, product size is too large, the spring action frequent bowl bearing pressure, power consumption rises. Have iron device to prevent excessive iron crushing chamber, if the iron is too frequent, it may cause the broken shaft accident. Increasing the moisture content quantity of viscous material can affect the throughput of material, the material on the water, it is generally not more than 5%. The use of power: the standard jaw crusher should reach 75% to 80%, short head jaw crusher should reach 80% to 85%. of Tin Crusher For Sale

Moving jaw by moving jaw and movable jaw plate bracket and other components, moving jaw broken jaw stent using 35 # steel, and after quenching Jaw crusher before starting guards should carefully check is good, found to be unsafe, should immediately eliminate it.

 

Features

Tin Crusher For Sale Long Service Life, Large Feeding Size, Stable Reasonable Design, Life Time Support,

Tin Crusher For Sale Operation Notes:

Because of the low initial high manganese steel hardness, low yield strength, impact strength in the non-conditions, the work hardening is not sufficient, easy flow and are cutting. To improve the life of the jaw, the development of the Sino-manganese steel. The steel was first invented by the Climax Molybdenum Company, and in 1963 officially included in the US patent. Its cast microstructure of austenite and martensite and a small amount of pearlite, the water toughening treatment, their organizations into a single austenite or austenite + a small amount of undissolved carbides (depending on the carbon content) tissue. Since then people have done a lot of research in manganese, that its hardening mechanism is: after lower manganese content, the austenite stability decreased in impact or abrasion, the austenite-prone strain-induced martensitic transformation, so that the wear resistance [4,7,8]. The manganese component is generally: 0��7% ~ 1.2% C, 6% ~ 9% Mn, 0.5% ~ 0.8% Si, 1.2% Cr, and other trace elements such as V, Ti, Nb, RE and the like. In manganese steel jaw in practical applications has also made good use of effects, such as the ratio of manganese steel jaw life increased by more than 20% [4,9,10] crushing silica, while the cost of high-manganese steel jaw quite. Therefore, in the medium and small jaw crusher used in manganese steel is a material worthy of the jaw.

 

Maintenance & Attention

When the cone crusher of ore must be given in the middle of the distribution disk, do not permit the ore directly into the crushing chamber. Because it is easy to make the crusher overload, making liner wear unevenly.Cone crusher feed ore distribution plate uniformly dispersed in the crushing cavity. Cone to the ore can not level up the bowl feeder when broken.The maximum size of the ore crusher, are not allowed to be equal to the mine mouth size (the maximum size of the block to the mine to the mine mouth size ≤85%) otherwise it will lead to: reduce the crusher production. Some other pieces of damaged crushers

 

To Choose a Right Tin Crusher For Sale

Optional spring cone crusher is also noted that when the feed size and equipment of the nesting size, shape and size of these parts directly affects the operational efficiency of the cone crusher. If the spout is too big or too small, so that operating power greatly increased, it may lead to substandard materials and components cone crusher for a great deal of damage.