This machine suit for lithium battery (or battery pack) flame resistance test. Drill a circular hole with a diameter of 102mm on an experimental platform, place a wire mesh on the round hole, place the battery on the wire mesh screen, install an octagonal aluminum mesh around the sample, and then ignite the burner heats the sample until the battery explodes or the battery burns, and the combustion process is timed.

WORKING PRINCIPLE

1 Drill a round hole with a diameter of 102mm on an experimental platform, and place a steel wire mesh on the round hole.

2 Place the battery under test on the steel wire mesh screen, install an octagonal aluminum wire mesh around the sample.

3 Ignite the burner heats the sample until the battery explodes or the battery burns out, and the combustion process is timed

STANDARDS

1. UL 1642:2012 “Lithium Battery Standard”

2. UN38.3(2012) “Recommendations on the Transport of Dangerous Goods-Manual of Tests and Standards” Part III

3. IEC62133-2012 “Safety requirements for batteries and battery packs containing alkaline or non-acid electrolytes”

4. GB/T 31241-2014 　 “Safety requirements for lithium-ion batteries and battery packs for portable electronic products”

SAFETY SYSTEM

1. Explosion-proof pressure relief device

2. Smoke exhaust device

3. Fire extinguishing system

4. Electronic door lock system

5. Safety stop switch

SPECIFICATIONS