TP10D is a power surge protector; it is used for surge protection of commercial lighting power sources such as street lighting (ClassI, ClassII), landscape lighting, and surge protection for power ports such as security, electrical appliances, and sockets.

 

TP10D has a fully sealed enclosure that is fire, water, dust and IP65 rated.
The lightning protection device adopts full mode protection, adopts UVT technology, and has leakage current and freewheelinginterruption function. The product is small and comes with L, N and PE cables for easy installation and application. The product's maximum protection lightning current is 10kA, which can withstand 10kV surge voltage shock.

 

 

1. UVT: It is an abbreviation of Ultra low voltage triggering technology. It is a design that absorb the high and low voltage energy of the surge in advance.
Advantages: It can absorb the surge energy more completely, and the residual voltage is low, and the protection effect on the back-end equipment is obvious. This technology is patented by Ruilongyuan.
2. Class I: In this paper, a luminaire that refers to “accessible conductive parts connected to protective earthing conductors in fixed wiring” (from IEC60598 - luminaires - general requirements and test - Chinese version).
3. Class II: In this paper, the term “light-protection protection is not only dependent on basic insulation, but also has additional safety measures, such as
double insulation or reinforced insulation, but no protective grounding or protection measures depending on installation conditions” (from IEC60598- Luminaires - General Requirements and Tests - Chinese version).

 

Applications:

1. Street lighting                                                         7. Security power supply

2. Outdoor and Commercial                                       8. Wash wall lighting
3. LED Lighting                                                          9. Parking garage/lot lighting
4. Roadway lighting                                                  10. Flood lighting
5. Traffic lighting                                                       11.Tunnel lighting
6. Digital signage

 

Notes:
1.The connection line of the lightning arrester will be connected after tining.
2.If there are no wiring terminals, wires should be welded,and the welds need to do isolation treatment.
3.L----Brown; N----Blue; PE---Yellow and Green.