TP20E is a power surge protector; it is used for surge protection of commercial lighting power sources such as street lighting (ClassI, ClassII), landscape lighting, and surge protection for power ports such as security, electrical appliances, and sockets. TP20E has a fully sealed enclosure that is fire, water, dust and IP65 rated.

The lightning protection device adopts full mode protection, adopts UVT technology, and has leakage current and freewheeling interruption function. The product is small and comes with L, N and PE cables for easy installation and application. The product's maximum protection lightning current is 20kA, which can withstand 20kV surge voltage shock.

1. UVT: It is an abbreviation of Ultra low voltage triggering technology. It is a design that absorb the high and low voltage energy of the surge in advance.
It can absorb the surge energy more completely, and the residual voltage is low, and the protection effect on the back-end equipment is obvious. This
technology is patented by Ruilongyuan.
2. Class I: In this paper, a luminaire that refers to “accessible conductive parts connected to protective earthing conductors in fixed wiring” (from
IEC60598 - luminaires - general requirements and test - Chinese version).
3. Class II: In this paper, the term “light-protection protection is not only dependent on basic insulation, but also has additional safety measures, such as
double insulation or reinforced insulation, but no protective grounding or protection measures depending on installation conditions” (from IEC60598- Luminaires - General Requirements and Tests - Chinese version).

Applications:

1. Outdoor and Commercial                 6.Security power supply
2. LED Lighting                                     7. Wash wall lighting
3. Roadway lighting                              8. Parking garage/lot lighting
4. Traffic lighting                                   9. Flood lighting
5. Digital signage                                 10.Tunnel lighting
11. Street lighting

Notes:

1.The connection line of the lightning arrester will be connected after tining.
2.If there are no wiring terminals, wires should be welded,and the welds need to do isolation treatment.
3.L----Brown; N----Blue; PE---Yellow and Green.