Wind Generator, buy 1KW Low Speed Maglev Vertical Axis Wind Turbine Generator 24V With Free MPPT Charge Controller on China Suppliers Mobile

Product Details

Product Description

1KW Low Speed Maglev Vertical Axis Wind Turbine Generator 24V

With Free MPPT Charge Controller

1. Low start up wind speed; beautiful appearance, low vibration operation, low noise.
2. Being installed by human design and easy for installation, maintenance and repair.
3. Being molded through precise injection with new process, together with the optimized design of aerodynamic contour and
structure, our wind turbine blades have such advantages:high utilization of wind energy which contributes to the annual energy
output.
4. Our generators, adopting patented permanent magnet rotor alternator, with a special kind of stator design. efficiently decrease
resistance torque of the generators

Product Paramenters

Model	RX-HV3-1000
Power	1000w
Rotor diameter	1.5m
Height of blades	2.2m
Blades material	Reinforce glass fiber
Number of blades	5
Rated Voltage	12V/24V/48V
Rated wind speed	11m/s
Rated RPM	500r/m
Start-up wind speed	2.5m/s
Work wind speed	3-25m/s
Survival wind speed	50m/s
Height of tower	6-9M
Generator type	Maglev generator
Control system	Electromagnet
Speed regulation	Automatically adjust windward direction
Lubrication way	Lubrication grease
Working temperature	From -40℃ to 80℃

Details Images

Drawn

Installation Instructions

1. Assemble the blade: Align the holes of wind wheel bracket and the blade, cover the bracket bolt with flat washer, then put it
through the hole of the wind blade, tighten the nut. So does the other blades

2. The installation sequence of the wind generators can follow the steps as the pictures.

2-1. Place the steel bracket on the ground; block up the flange joint to 1.3m.

2-2. Align the wind generator flange to the tower flange. Cut away insulating layer of current transmission wire end (which are
to be connected with controller) for 10mm, then short circuit the exposed copper wires (screwed together)

2-3. Fit the flange bolt with flat washer,make its head above, bolt thread below, put it through the appropriate hole of the
flange base. And then connect it to the tower flange. sheath the flat washer, spring washer in the bolt thread, and finally
tighten the nut in the flange bolt wire with a wrench. So does the other blots, flat washers, spring washers ,nuts and so on.
Tightening force can refer to pic-2

3. Mount the bracket on the wheel hub, cover it with the clamp, fit the stainless steel bolts with spring washer, flat washer ,
and then put it through the hole of the hub, tighten the bolts.

Free Controller

Our Factory