Overview:                                                                                               
    This product is suitable for all kinds of iron, plastic, glass, paper, cans, etc. of tinplate, aluminum lid, the lid seal. Quality, reliable, simple, lightweight, food, beverages, tea and other industries essential ideal equipment.

Features:                                                                                                 
    This product is suitable for sealing all kinds of iron, plastic, glass, paper, cans and other round containers, reliable quality, a "simple, quick action," the characteristics of the food, beverage and other industries essential ideal equipment.

Technical Parameters:                                                                           

Product Display:                                                                                     

Operation points:                                                                                   
First, adjust the product of different diameter
Turn off the power switch, loosen the lock nut support plate, the size of the workpiece to move out of adjustment shaft. Remove the upper ram and a lower mold, put the required pressure on the head and lower die, according to the following second, three to complete diameter and height can be adjusted.

Second, adjusting the diameter of the workpiece
Loosen the lock nut under the support plate, the pressure in the wheel does not touch on the head of the premise (more ram, the first pinch rollers, the workpiece size adjustment shaft into the center three-point line) will be the first pressure roller is adjusted to the pressure head at a distance of about 2mm, the lock nut tight lock to 3 minutes, then pull the handle to come and look at the second round airway pressure to keep the distance between the indenter whether with the first pressure on the wheel and the distance between the indenter, if two press wheels to keep the distance between the head of the relatively large difference, then you should use to adjust the eccentric shaft between the two press wheels to keep the indenter distance, and generally the first round than the second pressure airway pressure wheel near the head point (about 0.5mm), the pace well and then fine-tune the adjustment screw slowly entered, and, in general, down to the first pressure wheel distance around the head about 0.5--0.8mm, ram pressure on the second track distance of about 0.8--1.2mm round about, at this time if the distance is not ideal for a pinch roller can be reused eccentric adjustment (this depending on the size of the effect may be) will be adjusted after the lock nut locking.

Third, adjust the height of the workpiece
Loosen the nut height adjustment lever, the lifting operation lever placed at the rise, put in a jar and lid, adjust the height adjustment screw height adjustment just stick to the head cover and then further raised after living about 1-2mm, to to the role of tanks and rotary seal lids, and then you can lock nut, then lift the operating handle placed at the decline.

Fourth, the trial closure
The above two steps can be adjusted after the trial closed, turn on the power switch, into a jar and lid, the lift operation handle placed at the rise, then the motor will rotate automatically. Right hand grasp the pinch roller handle successively the first round and the second pressure airway pressure wheel pressure over the upper ram (Note: pull the handle speed can not be too fast, steady hand to, otherwise there will be blocked out of a sense or wavy edge flash), airway pressure when the second round of the ram pressure over backward to leave approximately 5--10mm, this time to lift the operating handle placed decline, the work is to follow after the end of mold fall into place in order to handle the pressure roller return, product out to see the effect, the effect can be produced with no problem, the result is not satisfactory can be reused as eccentric adjustment.

After-Sales:                                                                                             

Our machines undergo an extensive and strict testing and quality control procedure, ensuring each and every item purchased meet global quality standards.