Plug in the power, the power switch is turned on, machine normal operation, you can start work. Put the tank cover It covers the on the tank mouth, the tank is placed on the tray, step on the pedal switch, the machine starts to work, sealing finish automatic stop. Take out seal pot continue to the last step; If you want to set the automatic continuous sealing, don't switch control, put pull rod fastening ring 's screw loosen, pull the lever to the left or right push away (when the machine drop, The pulling rod does not touch the travel switch), then tighten screw.

1.Diameter is different, need to be equipped with corresponding upper pressure head and a tray. The tray can be by hand directly take out. Using a wrench to upper pressure head Replacement Then tighten the. Adjust left and right sealing hob distance between, Reference ex-factory jar sealing hob distance between.

2.The sealing the same caliber highly different jar : need to match the corresponding screw stem.

3.Height, diameter were not the same jar : push 1, 2 steps were adjusted.

Maintenance

1.Before using the left and right hob press locking mouth pad, the lifting work table to be wiped clean.

2.The rotating parts of lubricating oil filling.

3.The abnormal situation should immediately stop check, troubleshooting.

4.Well-connected ground wire