1.incubator body   2. controller   3.door handle   4. power supply  

5.outer door  6. fan cover   7. inner chamber   8 door button   

9 mesh board

PID self-tuning 

When temperature control is not ideal, You can use PID. During PID setting, temperature can fluctuate, please consider it as a factor towards end result.

In non-setting mode, press “shift” for 6 sec. to enter PID mode. “AT” indicator light flashes, the indicator light stops flashing when it finishes. The control system will obtain new set value of PID parameter, then auto-save the data. During auto-setting, long press “shift/self-tuning” button for 6 seconds to stop.

During self-tuning, if there’s over-heating, “ALM” indicator light is on, heating alarm relay will automatically detach, but beeper will not beep. During auto-setting, “set” button is unavailable. No matter whether there is setting for temperature control timing. Lower screen of the control panel will always display set temperature during auto-setting.

Thermostatic Incubator:

/Thermostatic-incubator/20170526/3.html