Solar panel Mechanical Load Testing equipment/PV Module withstand force deformation testing machine/PV module testing machine

 

Solar panel Mechanical Load Testing equipment/PV Module withstand force deformation  testing machine/PV module testing machine 

 

Standard

It’s conform IEC61215 2005 & 2016 ,IEC61646 and IEC TS 62872-2016 etc testing standard

 

Purpose

This test is to determine the ability of the module to withstand wind , snow , static or ice loads

 

Technical specifications

Testing standard	IEC61215-2:2016
Test Positive load	+10000Pa
Reverse load	-6000Pa
Cycle times	free setting
Dynamic load test frequency	7s±3s
Dynamic load	1000Pa,1000 cycles
Pressure control accurate	5%
Pneumatic and force value feedback ways	low friction force cylinder,tensile pressure sensor(accurate 0.1N)
The maximum test dimension	2.2*1.3m
Current continuity system	DC power, DC 120V/20A, real-time monitor module inner current continuity
Cylinder	8 pcs
Sucker	diameter 120mm, quantity 32 PCS
Control ways	Computer control
Electricity	220V 50HZ

 

 

 Procedure

1.Equip the module so that the electrical continuity of the internal circuit can be monitored continuously during the test

2.Mount the module on a rigid structure using the method prescribed by the manufacturer including the mounting means (clips/clamps and any kind of fastener) and underlying support rails, if t here are different possibilities each mounting method needs to be evaluated separately , for all mounting methods , mount the module in a manner where the distance between fixing points is worst case, which is typically at the maximum distance. 3.On the front surface , gradually and uniformly apply the test load, load uniformity needs to be better than ±5% across the module with respect to the test load, maintain his load for 1h

4.Apply the same procedure as in step c to check back surface of the module or as uplift load to the front surface

5.Repeat step c and d for a total of three cycles

 

 

Site Demand

NO	Project	Requirement
1	Placed dimension	2650×2320×2650mm(L×W×H)+740×740×1413mm(L×W×H)
2	Weight	Approx 800kg
3	Compressor air requirement	≥0.7Mpa, flow≥2.0m3/min
4	Electricity requirement	1phase 220V 50HZ
5	Ground requirement	Ground line connect to the ground
6	Area requirement	Flat
7	Environment requirement	25℃±2%,humidity 50%~70%, no noise , Shockproof, non-magnetic interference
8	Power	6000W

 

PV Module Testing machine's pictures display