BND293 Vacuum cleaner cable dynamic pressure resistance test machine

Equipment Overview:

The equipment is designed according to UL507 requirements of the wire dynamic pressure test equipment, the test will be on the power line up and down the mold, through the upper and lower die on the sample pressure, try the power line insulation layer of the pressure resistance, test sample connected to the low voltage DC Power supply, the connection indicator to determine whether the power cord insulation is broken, this signal is transmitted to the PLC at the same time to stop the device pressure test.

1. Double-column double-wire structure, equipment, even force, balance.

2. The use of motor-driven, smooth pressure, no gas source.

3. The upper mold seat with elastic adhesive retention mechanism, can guarantee the pressure time pressure stability.

Function parameter:

1. Compliance with UL507 standard requirements dynamic pressure test.

2. Upper mold structure: isosceles right angle triangle structure, side length 40mm, the top of the R1.2mm rounded, die length 80mm.

3. The upper mold is bolted to the upper mold base.

4. Upper and lower mold specifications: L100mmXW100mmX10mm.

5. Pressure detection device: digital electronic pressure gauge, you can set the detection pressure, display the current value of the pressure, set the value, you can clear the current value.

6. Press the way: motor + screw pressure.

7. Test action: high-speed down, low-speed pressure, the pressure reached when the high-speed rise.

8. Die movement speed: 10mm / min (high speed), 5mm / min (low speed).

9. Test mode: dynamic pressure.

10. Holding time: 0-99h99m (can be set).

11. Maximum test pressure: 5KN.

12. Sample damage detection: DC signal detection.

13. Number of test samples: 1 sample.