IEC #100/112 | 220VAC (Customized DC 24/48/60/72/96V) | ||||||
Rated output | KW | 2.25 | 3.75 | 5.5 | |||
Rated torque | N.m | 21.49 | 35.81 | 23.88 | 11.94 | 35.02 | 17.51 |
Rated current | A | 8.54 | 14.23 | 14.23 | 14.23 | 20.87 | 20.87 |
Rated speed | rpm | 1000 | 1000 | 1500 | 3000 | 1500 | 3000 |
Peak torque | N.m | 64.46 | 107.44 | 71.63 | 35.81 | 105.05 | 52.53 |
Maximum speed | rpm | 1200 | 1200 | 2000 | 5000 | 2000 | 5000 |
Torque constant | N.m/A | 2.52 | 2.52 | 1.68 | 0.84 | 1.68 | 0.84 |
Induced voltage constant | V/Krpm | 205 | 205 | 127 | 67 | 127 | 67 |
Rotor inertia | Kg.m^2 | 0.00641 | 0.0084 | 0.00641 | 0.0044 | 0.0084 | 0.00641 |
IEC #100/112 | 380VAC (Customized DC 24/48/60/72/96V) | ||||||
Rated output | KW | 2.25 | 3.75 | 5.5 | |||
Rated torque | N.m | 21.49 | 35.81 | 23.88 | 11.94 | 35.02 | 17.51 |
Rated current | A | 4.90 | 8.17 | 8.17 | 8.17 | 20.87 | 11.98 |
Rated speed | rpm | 1000 | 1000 | 1500 | 3000 | 1500 | 3000 |
Peak torque | N.m | 64.46 | 107.44 | 71.63 | 35.81 | 105.05 | 52.53 |
Maximum speed | rpm | 1200 | 1200 | 2000 | 5000 | 2000 | 5000 |
Torque constant | N.m/A | 4.38 | 4.38 | 2.92 | 1.46 | 1.68 | 1.46 |
Induced voltage constant | V/Krpm | 355 | 355 | 205 | 116 | 205 | 116 |
Rotor inertia | Kg.m^2 | 0.00641 | 0.0084 | 0.00641 | 0.0044 | 0.0084 | 0.00641 |
VIEW MORE PLS CONTACT US >>>
Q:Motor has been running then fails to start,what to do?
A:Likely cause: Fuse or circuit breaker is tripped.
What to do: Replace the fuse or reset the breaker.
Likely cause: Armature is shorted. Motor may make a humming noise and the circuit breaker or fuse will trip.
What to do: Disassemble motor and inspect the armature for a burnt coil. Inspect the commutator for burnt bars. If this condition exists, the motor needs to be replaced.
Likely cause: The brushes may be worn down too far and no longer make contact with the commutator.
What to do: Check the brushes to make sure that they are still making contact with the commutator. Contact manufacturer for brushes.
Likely cause: Controller may be defective.
What to do: Verify voltage is coming out of the controller.
Q: On initial installation, motor fails to start up,what to do?
A: Likely cause: Motor is incorrectly wired
What to do: Verify that the motor is wired correctly.
Likely cause: No output power from controller.
What to do: Measure voltage coming from the controller.
Likely cause: Motor is damaged and the armature is rubbing against the magnets.
What to do: Disassemble motor and see if the armature can be realigned by reassembly. Motor may have to be replaced.
Q: Motor takes too long to accelerate,what to do?
A: Likely cause: Motor controller not properly set.
What to do: Adjust the acceleration trim pot of the controller.
Likely cause: Brushes are worn.
What to do: Verify brush length.
Likely cause: Bearings may be defective.
What to do: Inspect bearings. Noisy or rough bearings should be replaced.
Q: Motor runs in the wrong direction,what to do?
A: Likely cause: Incorrect wiring
What to do: Interchange the two motor leads.
Q: Motor runs OK but has a clicking noise,what to do?
A: Likely cause: Suspect a burr on the commutator.
What to do: Remove burr from commutator using a commutator stone.
You May Like
- 12v 24v 10w 15w 30w 50w 100w 150w brushless dc motor
- High Torque 36V 48V 72V 24v 500w brushless dc motor
- 48V 750W 1500RPM PMSM motor
- Integrated motor 0-1100RPM MODBUS communication
- High quality 48v 600W 800W 1000w 1200W 1500W brushless dc motor
- high torque 12v dc motor 10nm flat brushless motor electric bldc brushless dc motor 12v
- 60v 48v 24v 12v 300w 350w 250w 500w 600w 1000w brushless dc motor
- Custom 12v 24v 36v 48v high power 56mm brushless dc motor
- OEM 1000W 1200W 48V 60V 72V Electric Vehicle Brushless DC Motor
- custom single phase 12V 1000W 1500RPM BLDC motor
Popular Searches
Find Similar Products By Category
You May Like
- customized BLDC motor with brake
- Custom factory supply tb6600 tb6560 8a 220v nema 23 42 43 34 3 phase brushless brushed dc motor
- High speed and low price 24V 3000rpm 42BL90 make brushless dc motormake brushless dc motor
- 4kw 4000w 5kw 7kw Electric BLDC Brushless DC Motor
- 12v 24v 15w 30w 50w 100w 150w 3000rpm bldc motor 57mm dia brushless dc motor
- 230V 3000W 1500RPM PMSM motor with brake hall IP54
- 48v 1hp 1kw 2kw 3kw 3000w 4kw 4000w 5kw 7kw Electric BLDC Brushless DC Motor
- Custom waterproof threaded rod nema brushless bldc brushed dc motor price
- Factory customize automatic machine and AGV nmrv30 worm reducer 200rpm 50Nm 60mm bldc Nema 24 geared 36V 250w bldc motor
- 24v brushless dc motor bldc 5000rpm 12v brushless dc motor 36mm brushless motor
- Customized high torque 12v 24v 48v 1000w brushless dc motor 3000rpm bldc motor
- Custom 12V 500W 3000RPM brushless dc BLDC motor B14 mounting bracket
- Custom made 12V 24V 36V 48V 60V 72V 90V 110V 1000W 2000W 3000W 5000W 7KW BLDC MOTOR
- China supplier 12V 24V BLDC motor 5W 15W 20W 35W 60W, brushless dc motor
- Chinese Supplier 2500rpm high speed low noise 500W 220V bldc brushless dc motor