What are the respective advantages and disadvantages of U-shaped spiral conveyor, tubular spiral conveyor and non-axis spiral conveyor
Since the center of the tubular spiral conveyor does not have the soft transport selected by the central axis planning, the blades and lining plates are closely adjacent, and the wear resistance of the lining plates depends on the effective work of the spiral blades. The blades of the tubular spiral conveyor are selected by choosing wear-resistant manganese steel raw material blades based on the thickness of the transported materials. The use of gravity dispersion to transport the parts of the screw feed machine creates a transverse force and pushes the material to stop the lateral exchange, and can perform no dust manipulation. At the same time, the material is transported without machine extrusion and fierce friction. The machine must be washed, operated and maintained during operation and maintenance after the application of tubular spiral feed machine accessories stopped. On the basis of the skills of our ancestors at home and abroad, the technical staff of our company, spiral feed machine accessories are suitable for the transportation of a variety of dry powder and fine granular materials, and they are more in the pursuit of the best quality in the work, pay attention to the speed reducer plus sufficient lubricant, and observe whether the electrical appliances can age. After the operation is stopped, the blades of the conveyor shall be washed in real time. The LS spiral conveyor is also compact in size when it is produced. Compared with other models of conveyor, his section size is also much smaller, and the area after installation will be much smaller. Especially in some large port loading business or play a large role in the help, we should recognize its different characteristics. Sometimes some special materials also need to be sealed transportation, it also has design standards at the time of transportation, can be completely sealed transportation, so we do not have to worry, the use is still very simple and convenient. In terms of specific loading and unloading, the advantages of the LS spiral conveyor are obvious, and reverse transportation can be achieved. Therefore, one conveyor can transport materials in two directions, so it is more flexible for our specific applications and less energy consumption. In the process of specific transportation, it can also reduce wear, allow longer service life, and have a lot of attention when loading. It also has a lot of room for improvement in the future transportation process. Using the LS spiral conveyor will help you save a lot.. In the process of using the non-axis spiral conveyor, we must also strictly check the old and new conditions of each component and update them in a timely manner. So as not to destroy other parts. If it is the chain-gear wear of the non-axle spiral conveyor, but it has not yet reached the point of throwing, then turn it over and apply it, as it can extend its service life. The non-axle spiral conveyor is usually not prone to blockage or the discharge port is not available. It can run at low speed, reduce energy consumption, and the non-shaft spiral conveyor has long transport intervals. It can adopt multi-stage serial devices and transport materials at ultra-long intervals.. However, in some moments, the living slag, when the inorganic animals are transported, will also cause the destruction of spiral blades. The thickness of the spiral blade is also more wear-resistant and durable, suitable for transporting materials. The spiral blade wear of the non-axial spiral conveyor is mainly on the edge of the blade. The farther away from the rotating axis, the greater the force, and the number of cracks that occur in the air. The more. There are elements of abrasion and transportation of the blades of the tubular spiral conveyor. When sand materials are transported, the abrasion of the blades will be stronger, and the abrasion of transporting sludge, sludge, kitchen **, etc. will be smaller. The thickness and raw materials of spiral blades and lining plates are selected according to the characteristics of transporting materials. For example: The pulp of a paper mill recovered from used cartons has a large amount of sediment. It takes less than three months to wear through with nylon lining. Note that this material increases the thickness of the blade and the thickness of the lining after the tube screw conveyor is selected. The nylon liner can be replaced with a manganese plate to reduce the degree of wear.