Commercial Shrimp Chips Production Line|
Negotiable /Set
Min.Order:1 Set
Zhengzhou LONGER Machinery Co, Ltd
Detailed introduction of Fried shrimp flake production line.
It is suitable for the production of puffed food enterprises.Raw materials are processed semi-finished shrimp chips.
The shrimp flake machine is fully automatic and continuous frying.It has the following characteristics:
The whole system is: tank, oil filter system, high pressure oil pump, heat exchanger, frying machine, centrifuge and electrical control panel.The whole system USES oil circulation heating, frying and filtration system.
The high pressure oil pump supplies the heat exchanger's oil to the frying machine, and the temperature is thermostat.
The tank will automatically detect the oil level in the fish machine. If the oil level is lower than the frying process, the oil will be added automatically.
After the product is Fried, it enters the centrifuge through the air-cooled conveyor belt, which is good for the oil and does not damage the product.
1.Purpose and Scope of Use of Shrimp Chip Making Machine
This shrimp cracker making machine is special equipment for shrimp crackers production, this machine has stable performance, wide applicability and the required less operators etc, mainly use corn starch, rice and potato starch as raw material, produce different type of prawn crackers.
2. What is Shrimp Chips
Shrimp chips, also named prawn crackers, shrimp crackers, krupuk, is a kind of deep-fried snack made from shrimp and starch, popular in East Asian cuisine.
3. Ratio of raw materials:
50 kg corn starch and water 19-20 kg, 50 kg of starch and salt 1 kg, 50 kg starch and 0.25 kg of cooking oil.
4.installation and use of Shrimp Cracker Production Line
1) Before using curing machine, add the oil 2 liters to gear box.
2) The machine should be installed on the flat solid concrete ground.
3)Check the machine parts is complete, the bolt is strong.
4)Confirm the parts in good condition, connect power, make the machine idle run for 2-3 minutes, no other exceptions, begin to work.
5) Pour mixed starch raw material into feeding machine inside the bucket, running for 1 to 2 minutes until temperature in cylinder rise, and then adjust the feeding machine speed.
Product Parameters
Mixing Machine
Model | GGD-25 |
Power | 3.0KW |
Capacity | 30kg/time/10min |
Size | 750*810*950mm |
Extruder
Cylinder Dia | 100mm |
Power | 18.5KW |
Capacity | 80-120kg |
Size | 1850*810*1950mm |
Power | Size | |
Mixing Machine
| 3.0KW | 750*810*950mm |
Extruder
| 18.5KW | 1850*810*1950mm |
Shaping Machine | 4KW | 850 * 540 * 790mm |
Cutting Machine | 3.55KW | 1050 * 610 * 750mm |
Email:ellie@machinehall.com
Whatsapp:18595717505