PIPE BEVELING MACHINE
 
The ID-Mounted beveling operation use an expandable mandrel which is insert into the open end of the pipe. Tighten
draw nut extend the expanding blocks and against the ID surface for positive mounting, self centered and squared to the bore. As the tool bit is fed into the pipe from the end, a bevel is finished which conforms to the bevel angle required. Bits are available for practically any material or beveling angle required, and bits can be custom made for any form tooling operation.
 
 
 
Features
 

In-Situ cold Beveling improves safetyEasy installation & OperationSelf-CenteringCan be placed in any directionFeed ratchet spanner makes tool feed or back easilyCompact design & Light weightElectric/ Pneumatic driven for optionAdjust Speed

 
 
 
Application
 

Oil & Gas filedPower PlantChemical PlantNuclear Power PlantProcess Plant & FabricationShip Building & Repair

 
 
 
Specification
 

Drive Options: Pneumatic, ElectricAir requirement: 900L-1200L/Min@0.6MpaElectric requirement: 220-240V 1PH 50/60HZFeed mode: Feed spanner, manuallyPackaging: Plywood case

 
 
 
Selection Guide
 

Model	Clamping Range (ID)		Working Range (OD)		Wall Thickness
	mm		inch	mm	mm
80	28-76		3	88.9	≤15
120	40-110		4	114.3	≤15
252	80-240		10	273.05	≤20

 
 
 
Typical Buttwelding Joint

 
 
 
Order Guide
 
Before you place order to us, please let us know the following information:
 

Choose the right Model

Confirm your electric power supply ( Voltage, frequency and phase)

Confirm the beveling angel required

Confirm the welding joint required (U, V, Double V or Compound preparation)

Advise your pipe material ( Carbon steel, stainless steel or others)

Other special demands about machine

The spare parts needed

If the pipe wall thickness more than 30mm, inform us in advance (Important)