Delivery Time:3-5 days
Certification:CE,FCC,MSDS

6KV - 8KV Tabletop Negative Ionic Air Purifier For Living Room / Garage

Specifications:

High output of negative ions at above 6-8kV Stainless steel pin electrodes  Flashing neon to indicate output pulses and battery status Ultrasonic frequency waves at about 30kHz Power consumption: <70 mA at 6V D.C Effective area 15-20㎡(150-200 ft sq.) Dimension: 76× 63×83mm(3” ×2 1/2” × 3 1/4”)

The product:

Negative ions are considered the “vitamin of the air”. Molecules usually carry a neutral charge; however, when molecules lose an electron, they become anions (negatively charged ions). Anions are relatively unstable, and will attract and trap any free electron pairs. As a result of this attraction, small air pollutants and dust molecules bind with anions, which become negatively charged and thus attracted to the ground, consequently being removed from the air and producing an air purifying effect.

The EP200 negative ion air purifier is compact in size, technologically advanced, and is capable of purifying air. It is suitable for use in places such as the bed room, living room, garage and storage etc. It generates a sine wave high voltage, which is applied to two stainless steel pins thus releases negative ions. These negative ions are relatively free from harmful NOx molecules, unlike the ions produced from using high voltage pulses. Because of the simple waveform used, the device gives minimal interference to nearby electrical appliances. This unit also generates a small amount of ozone which is well below the international health safety standard of 0.08ppm over 8 hours. 

The package:

There are five items in the box:

The EP200 unit The mounting bracket with screws 4×AA alkaline batteries AC/DC adaptor or switching mode power adaptor The instruction manual

Installation:  

1. Push the battery cover downwards to open. Install four alkaline AA batteries into the battery compartment. (The terminal with a spring is the negative terminal.) Replace the battery cover.
2. For continual indoor use, use the power adaptor supplied:
a. Use the two screws provided to fit the mounting bracket onto the back of the unit
b. Insert the round shaped outlet of the power adaptor into the only socket at the back of the unit, and plug the other end to an appropriate electrical socket on the wall.
3. Place the unit at a convenient position so that the negative ions and ozone will be most effectively dispersed throughout the room.

Operation:

Gently press the ON/OFF button once to switch ON the unit, as will be indicated by the flashing neon LED and the feeling of static wind at the output holes at the top. Do not press the ON/OFF switch for too long as it may then turn the unit OFF. To turn it OFF, hold the button for about 2 seconds.
A set of batteries should provide 15 hours of use. When the speed of the flashing neon becomes very slow, the batteries should be replaced.

Notice:

Always keep the unit clean with a dry cloth. Use alkaline batteries because the unit requires even discharge characteristics. Do not use an unregulated power adaptor, especially one with higher rating than 6V D.C 100mA. Use only the power adaptor supplied. Do not attempt to repair the unit, because there are no serviceable parts inside. Do not use in wet environments.