ESD Hot Air Rework Station With LED Temperature Display 220V , Solder Stations

1.First memory segment defaults to 200oC , 5 seconds

2.Second memory segment defaults to 300oC , 17 seconds

3.Third memory segment defaults to 240oC , 12 seconds.

when was working  first temperature to 200 oC, and then work to maintain this temperature for 5 seconds , and then heated to 300oC , to maintain this temperature for 17 seconds of work , in the cooling to 240oC , to maintain this temperature for 17 seconds of work, after the completion of these three stages automatically into standby mode 

ESD Hot-Air Rework Station With LED Temperature Display , Solder Stations Features

1. Comfortable portable handheld and microcomputer control temperature , LED display, big power , warming-up quickly , the temperature accuracy and stability , without the wind effect, the real lead-free soldering.

2. Intelligent digital operation, microcomputer software to 5 ‰ s real-time tracking tip temperature , the temperature especially stable.

3. Handle with sensor switch , Taking the handle , the system enter the working mode ; handle released into the handle frame, the system will enter standby mode , real-time operating convenience.

4. Function tips and fault alarm. If parts , heater , the circuit board failure and welding station which may burst failure signal , prompted the staff to check.

5. System with automatic cold air function , prolonged heating elements life and protect hot air gun.

6. Using the latest intelligent control program , according to the time needed to set the time ( CH1.CH2.CH3 three keys can set three time ) required with the time and each time a different temperature settings to use.

7. Use brushless fan , with lowest noise and long lifetime ; using high-quality heating element , in the same power efficiency can be doubled, which can effectively extend the service life of body heat and power savings.
8. Each time power is turned on , the handle should be ( placed ) in the handle of the frame, the machine can begin work. [If not  ( put ) in the handle of the frame, the main unit can not detect safety instructions , so the machine does not work. ] The aim is to prevent misplacing or error on the handle due to unsafe or flammable place (work) and lead to adverse consequences.
9. Machine is small and take up a little work area.

10. Machine case use alloy materials,nice apprance and durable.

11. It is certificated ESD safe.

ESD Hot-Air Rework Station With LED Temperature Display , Solder Stations Technical datas

Power consumption 700w

Gun Temperature range 100-480°C

Gun heater materical Nickel alloys

Gun heater resistance 74Ω

Gun type Brushless Fan

Air flow 120L / min

Inner box Dimension (cm) 26*16.5*14.8

Outer box Dimension (cm) 54*35*31

QT 8PCS / ctn

N.W. 1.75KG / PCS

G.W. 2.1KG / pcs

What\'s In The Box

* main unit + gun + power cord

* guide

* 3 nozzles

ESD Hot-Air Rework Station With LED Temperature Display , Solder Stations Display

These are 220V units , you may need a transformer to use the machine in your country. we also do accept special orders for 110V / 230V / 240V units.