Breath Alcohol Tester with 3-color Backlight with Micro USB Interface, Suit for Samsung, Sony Xperia and other Mobile Phone
Negotiable /Piece
Min.Order:50 Pieces
Shenzhen Capital Electronics Co., Ltd.
Breath Alcohol Tester with 3-color Backlight with Micro USB Interface, Suit for Samsung, Sony Xperia and other Mobile Phone
Features:
This product is a suitable for Samsung Galaxy S IV / S III / SII / N7100 / HTC One X / Sony Xperia ST25i, compact, refined, very conducive to carry.
1) With a new gas detection technology can more accurately detect the alcohol content of the gas.
2) LCD digital color backlit screen display makes intuitive detection and effective.
3) Unique probe can effectively distinguish smoke, cola, coffee and other non-alcoholic gas interference.
4) With audible alarm function, alcohol level gauge, the buzzer alarm.
5) Use the phone powered directly access the Samsung Galaxy S IV / S III / SII / N7100 / HTC One X / Sony Xperia ST25i can be used.
6) Without the blowpipe, the gas is blown into the pores, health, clean.
User Manual
1. Will the access i9300 products, then the phone unlock, then long press switch tester, tester is a squeaking hum, this LCD screen is green And have the corresponding display.
2. The state of a warm up Numbers from 10 to 0, then finish preheating process at this time.
3. State blow for 10 seconds when the countdown to the mouth near the tester is the porosity, and continuous within 3-5 seconds exhaling into the sensor, after the countdown, display screen Will show test results, if not detected alcohol or alcohol content is normal, the LCD screen has kept green.
4. When the test results to the following scope, the LCD screen into a yellow "Caution" and "warning" words will show; Square root 0.02% BAC (0.2 g/l) or to0.05 % BAC (or 0.5 g/l)
5. When the test results to the scope of the following, a red LCD screen and "Danger" "dangerous" duration of words will be showed, buzzer alarm; Tick over & EQUAL 0.05% BAC (0.5 g/l) or over & EQUAL 0.08% BAC (or 0.8 g/l)
1. Often there will be some gases or debris attached on the surface tester sensor, so when the first time the tester from the packaging or a long time When using the tester, need time to clean and preheating sensors, if possible, the user needs to press power on key several times as much as possible.
2. If the measurement after smoking, drinking, eating, suggested measure interval after 20 minutes.
3. To make the test results more accurate, test time from the last test best more than 3 minutes.
4. Avoid strong winds or used under severe polluted environment.
5. Please don't put the cigarette smoke, food or liquid into the instrument, otherwise it will damage the sensor.
6. Please do not squeeze or drop on this product.
7. In order to you and others safety, please do not drink and drive.
More Photos: