MYJG100W power supply for CO2 laser tube adopts zero-current half-bridge soft-switch circuit to ensure the equipment has the advantages of high efficiency and rapid response speed, applying to laser tubes from different factories.

Its simple control port is applicable to high/low level signal. TTL level is to control the on/off of the laser with an anomalistic protective switch to check water-flow and ventilation, etc.

Adjust the power: Input analog signal(0~5V) or PWM to control the output power.

Open power protection in the power supply has these functions: the power supply can work for a short time in the state of open circuit while the case touches the ground well so as to avoid damage to the power supply caused by the laser tube burst.

Ageing check before consignment:

Each power supply before selling will go through the aging check:

(1) sustain 10 hours at temperature 60 degrees Cenciusunder full-load condition;

(2) 500 times on/off check for 7 seconds.

The power supply comes with a full year warranty since the formal acceptance date.